4.Set four Weight Bumpers (19) onto the Base (8) and align them with the indicated holes.
Insert both Weight Guides (23) through the Weight Bumpers (19) and the holes in the Base (8).
Slide eight Weights (26) onto the Weight Guides (23).
Make sure all of the Weights are turned so the pin grooves are on the same side and are oriented as shown on the drawing.
4
23
26
Pin
Grooves
19
19
8
5.Press the Weight Tube Bumper (64) into the end of the Weight Tube (25).
Insert the Weight Tube (25) into the stack of Weights
(26).Make sure the pin on the Weight Tube is resting in the pin groove in the upper Weight.
Lubricate the insides of the holes in the Top Weight
With the slot facing down, slide the Top Weight onto the Weight Guides and set it on the stack of Weights
6.Slide two 5/16Ó Flat Washers (56) onto two 5/16Ó x 2 3/4Ó Bolts (67).
Place the Top Frame (1) on top of the Front Upright
(42)and align the indicated holes with the holes in the bracket (C) on the Upright.
Insert the 5/16Ó x 2 3/4Ó Bolts (67) through the Top Frame (1) and the bracket (C) on the Front Upright (42). Hand tighten a 5/16Ó Nylon Locknut (53) onto each Bolt.
Do not tighten the Locknuts yet.
5
16
Slot 
| Pin |
|
| 25 |
|
| 64 |
|
Pin |
|
|
Groove |
|
|
| 26 |
|
6 | 56 | 67 |
|
| |
1 |
| 56 |
| 53 | C |
|
| |
| 42 | 53 |
7