Trouble-shooting and Maintenance
Inspect and tighten all parts each time you use the home gym system. Replace any worn parts immediately. The home gym system can be cleaned using a damp cloth and mild
Tightening the Cables
Woven cable, the type of cable used on the home gym system, can stretch slightly when it is first used. If there is slack in the Cables before resistance is felt, the Cables should be tightened.
To tighten the Cables, insert the Weight Pin (39, not shown) between the third and the fourth Weight, counting from the top. See ÒChanging the Weight SettingÓ on page 17 for instructions on moving the Weight Pin.
Loosen the 5/16Ó Plain Nut (32) holding the Eyebolt (44) to the Leg Lever (29). Tighten the Eyebolt a couple of turns until the Cables feel tighter. Tighten the Plain Nut to prevent the Eyebolt from turning.
Additional slack can be removed by moving the
(6)to one of the other holes in the bracket (P) on the Seat Frame (36). To do this, remove the 3/8Ó x 3 1/4Ó Bolt (69), Cable Trap (66), 3/8Ó Flat Washer (55) and 3/8Ó Nylon Locknut (63). Move the
Note: If a Cable tends to slip off the Pulleys often, the Cable may have become twisted. Remove the Cable and
If the Cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual.
1 |
|
44 | 29 |
| |
32 |
|
1 |
|
36 |
|
P |
|
63 |
|
55 |
|
6 |
|
66 |
|
69 |
|
19