Weider WESY37531 user manual Attaching the AB Strap to the AB Pulley Station

Page 22

ATTACHING THE AB STRAP TO THE AB PULLEY STATION

Attach the Ab Strap (81) to the Ab Cable (47) at the ab pulley station with a Cable Clip (69).

ADJUSTING THE BACKREST

To adjust a Backrest (12), loosen the Adjustment Knob

(5)on the Press Upright (2) or the Butterfly Upright (not shown) by turning it counterclockwise and pulling it out as far as possible. Slide the Backrest forward or backward to the desired position, and snap the Adjustment Knob into a hole in the Backrest Frame (not shown). Secure the Backrest by turning the Adjustment Knob clockwise until tight.

ADJUSTING THE CURL PAD

Remove the Large Adjustment Knob (46) from the Butterfly Front Leg (3).

Align the holes in the Butterfly Front Leg (3) with the desired set of holes in the Preacher Post (39). Re- insert the Large Adjustment Knob (46) through the holes in the Butterfly Front Leg and the holes in the Preacher Post. Turn the Large Adjustment Knob clock- wise until tight.

Note: When not using the Curl Pad (91), store it away from the weight system.

47

69

81

2

12

5

91

46

39

3

22

Image 22
Contents QUESTIONS? Model No. WESY37531 Serial NoTable of Contents Important Precautions Before YOU Begin Using the weight system. If you have additionalFor your benefit, read this manual carefully before Assembly Make Assembly EasierFrame Assembly Nylon Locknuts yetDo not tighten the Nylon Locknuts 50 yet Do not tighten the Nylon Locknuts yet Locate and open the parts bag labeled ARM Assembly Tighten the Nylon Locknuts 50 used in stepsPage Cable Assembly Nylon Jamnut the Leg Lever must pivot easilyTrap is turned to hold the Cable in place Page Weight Cable is in the groove of the 3 1/2 Pulley Cable Trap is turned to hold the Cable in place Cable Trap is turned to hold the Cable in place Locknut yet Page Seat Assembly Locate and open the parts bag labeled Seat AssemblyPage Adjustments Changing the Weight SettingAttaching the AB Strap to the AB Pulley Station Weight Resistance Chart PlatesTroubleshooting Tightening the CablesCable Diagrams Weight Cable Cable ID Stack Low Pulley Page 2 Square Inner Cap 3 Inner Cap 2 x 2 1/2 Inner Cap Part Identification CHART-Model No. WESY37531 R1003AX 4 Bolt X 4 3/4 Bolt X 5 1/2 Bolt Part LIST-Model No. WESY37531 Qty DescriptionModel No. WESY37531 Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT