Weider WESY37531 user manual Tighten the Nylon Locknuts 50 used in steps

Page 9

12.Secure the Press Top Frame (9) to the Butterfly Top Frame (33) with two 3/8” x 3 1/4” Bolts (62), two 3/8” Flat Washers (48), and two 3/8” Nylon Locknuts (50). Do not tighten the Nylon Locknuts yet.

13.Secure the Weight Guides (15) to the Press Top Frame (9) with two 3/8” x 1 3/4” Bolts (57) and two 3/8” Nylon Locknuts (50).

Tighten the Nylon Locknuts (50) used in steps 2–13.

ARM ASSEMBLY

14.Locate and open the parts bag labeled “ARM ASSEMBLY.”

Press a 1 1/2” Square Inner Cap (35) into the Right Pivot Arm (85).

Lubricate the axles on the Butterfly Top Frame (33). Secure the Right Pivot Arm (85) to the right axle with two Retainer Rings (31) and a 1” Round Outer Cap (38). Do not confuse the Right Pivot Arm with the Left Pivot Arm (not shown). The Retainer Rings may break if disassembled.

Note: Be sure the Retainer Rings (31) and 1” Round Outer Cap (38) are oriented as shown in the inset drawing.

Repeat this step with the Left Pivot Arm (not shown) and left axle.

12

 

 

 

50

62

 

48

 

9

48

 

 

 

 

33

13

57

 

 

 

 

9

 

 

50

50

 

 

 

15

 

14

 

 

 

 

33

 

 

Lubricate

 

 

85

 

35

31

 

Axle

38

31

 

 

 

38

 

9

Image 9
Contents Model No. WESY37531 Serial No QUESTIONS?Table of Contents Important Precautions Using the weight system. If you have additional Before YOU BeginFor your benefit, read this manual carefully before Make Assembly Easier AssemblyNylon Locknuts yet Frame AssemblyDo not tighten the Nylon Locknuts 50 yet Do not tighten the Nylon Locknuts yet Tighten the Nylon Locknuts 50 used in steps Locate and open the parts bag labeled ARM AssemblyPage Nylon Jamnut the Leg Lever must pivot easily Cable AssemblyTrap is turned to hold the Cable in place Page Weight Cable is in the groove of the 3 1/2 Pulley Cable Trap is turned to hold the Cable in place Cable Trap is turned to hold the Cable in place Locknut yet Page Locate and open the parts bag labeled Seat Assembly Seat AssemblyPage Changing the Weight Setting AdjustmentsAttaching the AB Strap to the AB Pulley Station Plates Weight Resistance ChartTightening the Cables TroubleshootingCable Diagrams Weight Cable Cable ID Stack Low Pulley Page 2 Square Inner Cap 3 Inner Cap 2 x 2 1/2 Inner Cap R1003A Part Identification CHART-Model No. WESY37531X 4 Bolt X 4 3/4 Bolt X 5 1/2 Bolt Qty Description Part LIST-Model No. WESY37531Model No. WESY37531 Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT