Weider WESY49310 user manual Seat Assembly Decal

Page 21

SEAT ASSEMBLY

DECAL

47.Press two 3/4” Round Inner Caps (34) into each Pad Tube (28).

Insert a Pad Tube (28) into the Front Seat Frame (36). Slide a Foam Pad (30) onto each end of the Pad Tube.

Insert the other Pad Tube (28) into the Leg Lever (29). Slide a Foam Foam Pad (30) onto each end of the Pad Tube.

48.Remove the backing from the CLUB WEIDER® 17.0ST decal and apply it to the weight system where shown.

Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in HOW TO USE THE WEIGHT SYSTEM, beginning on page 22 of this manu- al.

Before using the weight system, pull each cable a few times to make sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE DIAGRAMS on pages 26 and 27 of this manual for proper cable routing. If there is any slack in the cables, you will need to remove it by tightening the cables. See TROUBLE-SHOOTING AND MAINTENANCE on page 25.

47
36
30
34
28
34
30
29
48
CLUB WEIDER®
17.0ST

21

Image 21

Contents QUESTIONS? Table of ContentsImportant Precautions Apply the decalLocation shown Before YOU Begin DimensionsFrame Assembly AssemblyFollowing Tools not Included are Required for Assembly Frame AssemblyNylon Locknuts yet Tighten all Nylon Locknuts used in steps Weights 25 until is completeTube is sitting in the pin grooves in the top Weight ARM Assembly Frame Assembly ARM AssemblyDo not tighten the Nylon Locknut yet 101 Bracket 105 106 107 ARM Assembly Cable Assembly Nylon Locknut the Pulley Bracket Must be able to move freely Long Cable Trap is positioned to hold Cable in place102 Locate the Low Cable 23. Route the Low Pulley and the crossbar on the PressMove smoothly Cable Assembly Cable Assembly Must be inserted from the side shown Locate the Leg Press Cable 99. Attach Locate and open the parts bag labeled Seat Assembly Seat AssemblySeat Assembly Seat Assembly Decal Changing the Weight Setting HOW to USE the Weight SystemAdjusting the LEG Press Plate Attaching and Removing the SeatAttaching the LEG Lever to the LOW Pulley Station Plates Weight Resistance ChartTightening the Cables TROUBLE-SHOOTING and MaintenanceHigh Cable 58 and Low Cable Cable DiagramsHigh Cable Low CableLeg Press Cable Military Press Cable 72 and Leg Press Cable Pivot ArmWESY49310 R0901A 16 x 3 Bolt Page Qty Description Part LIST-Model No. WESY49310Exploded DRAWING-Model No Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT