24.LocatetheLegLeverCable(32),whichhastwo 24 endsthatarethesamelengthandathirdend thatislonger.
RoutethelongestendoftheLegLeverCable (32)throughtheholeintheFrontLeg(6),and attachit insideoftheholeintheLegLever(7) withanM10x 6OmmBolt(63)and an M10 Nylon
Locknut (76).
25.Attach a 90mm Pulley (28) inside of the hole in the Front Leg (6) with an M10 x 91ram Bolt (90), two 26mm Spacers (52), two M10 Washers (75), end an MI0 Nylon Locknut (76). Be sure the
Pulley is above the Leg Lever Cable (32). Slide the two free ends of the Leg Lever Cable
(32)onto the hook welded to the bottomof the
Bench Rail (5).
26.Locate the two Short Cables (33). Wrap one of the Cables around a 90mm Pulley (28). Attach the Pulleyto a High Pulley Housing (21) with an M10 x 42mm Button Head Boit (71) and an M10
Nylon Locknut (76).
Repeat this step with the other Short Cable (33).
25
6
9O
Hook
76
26
76
21
71
27. Slide the four Foam Pads (26) onto the tubes on | 27 | 26 |
the Front Leg (6) and the Leg Lever (7). Press four 19ram Round inner Caps (78) into the ends of the tubes.
26
7
26
28.Make sure that all parts have been propedy tightened. The use of the remaining parts will be explained in ADJUSTMENTS, beginning on the followingpage,
Before using the resistance system, pull the long cable a few times to be sure that it moves smoothlyover the pulleys. If the cable does not move smoothly,find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy resistance is used. See the CABLE DIAGRAM on page t6 for proper cable routing.
12