Weider WESY59421 user manual Assembly, Befo l==Nng a=.bly, make=am that

Make Thk'tg=F.al_r for Youmeif

TNsm_ual _s€_ned.to_ thatmerest-

ante_ canhe'assembled by

most people, However, it I_,i_= ntt0 reallz8 that the versatile re,stance system has r_ny

partsandtt_t'theas_ pro=='_lltake

UmeM._t _op_ _ _at W s6_ngask_pk_ty of_. assemUy g0_=_t_y.

Before beginning assembly, carefully read the following information and instructions:

•Assembly requires two persons.

•Place all parts m a cleared area and remove the packing materials. Do not d_sposeof the packing materials until assembly is completed.

•For help identifying small parts, use the PART IDENTIFICATION CHART. Note: Some small

parts may have been pre-attached for shipping. If a part is not in the parts bag. check to see if it has been pre-attached.

•Tighten all parts as you assemble them. unless instructedto do otherwise.

•As you assemble the resistance system, make sure all parts are odented as shown in the draw- ings

The included IAIlen wrenche.e.e.ande.e.ethe. .efollow.e- ing tools (not included) are required for assam- bly:

•Two adjustable wrenches

•One rubber mallet

•One standard screwddver

•One Phillips screwdriver

•Lubricant, such as grease or petroleum jelly, and soapy water.

Assembly will be more convenient if you have a socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches.

Befo_ l=_=Nng a=._bly, make=am that 1

you hayedraad =nd nmda_,_tand _ lion In lIND_

Press two 50mm Square Inner Caps (98) into the

Base (1).

Attach two Plastic Feet (53) and two Large Plastic Feet (102) to the Base (1) w=thfour M4 x 16mm

Screws (62).

Attach the Upnght (3) to the Base (1) with two M10 x 66ram Carriage Bolts (83), two M1O x 72mm Bolts (64). and four M10 Nylon Locknuts (76) as shown. Note: This step will be easier to

complete if the Updght and Base are tipped on their sides.

3

64

76

o_,_," 76

_o_---102