Electrolux EWP 106100 W, EWP 126100 W, EWP 86100 W Button 6 starts flashing the appliance is now

Page 15

electrolux 15

7


						2			3			4			5		6
	Programme selector				Turn the programme selector dial to the required
1	Programme selector				Turn the programme selector dial to the required
	dial				programme. The selector dial can be turned either
					clockwise or counter-clockwise. The green pilot light
					of the button 6 starts flashing: the appliance is now
					switched on.

If you turn the programme selector dial to another programme when the appliance is working, the red pilot light of the button 6 will flash 3 times to indicate a wrong selection. The appliance will not perform the new selected programme.

•To switch the appliance off, turn the programme se- lector dial to the position .

•To cancel or change a running programme, switch the appliance off by turning the programme selector

dial to the position . Select the new programme by turning the selector to the desired programme. Start the new programme by pressing the button 6 again. The water in the tub will be not emptied out.

2	Temperature button	Push the temperature button to select the most
		suitable temperature for washing your laundry .
		: Cold wash.

Image 15

Contents Washing Machine Safety Information ContentsUSE InstallationChild Safety This appliance must be connected to a cold water supplyFrost Precaution Environment ConcernsPackaging Materials Technical Data Product DescriptionEcological Hints Installation UnpackingNecessary tools Positioning and Levelling Onto a sink outlet spigot Hooked over the edge of a sink using the plastic hose guideWater Inlet Water DrainageDirectly to a built-in drain pipe in the room wall Electrical Connection Special AccessoriesFirst USE Connections OverviewBefore Loading the Laundry Daily USESort OUT the Laundry Ball point pen and glue moisten withDegrees of Water Hardness Maximum LoadsClose the Door Gently Detergents and Additives Quantity of Detergent to be UsedUP- Flap position if using Powder de- tergent Flap for Powder or Liquid DetergentFlap is down and you wish to use powder detergent Close the Detergent Dispenser Drawer SET Your Washing Programme Measure OUT the Fabric SoftenerButton 6 starts flashing the appliance is now Extra Rinse Delay StartSelect a delayed start Rinse HoldAT the END of the Programme Indicator pilot lightsStart/Pause Start the programme by pressing the button Opened pay attention to the water level and temDoor Seal Washing ProgrammesSynthetic Spin Consumption Values Care and CleaningMaintenance Wash Cleaning the Dispenser DrawerCleaning the Drain Filter Remove the filter and clean it under the tap What to do IF… Cleaning the Water Inlet FiltersMalfunction Replace it with a new one Programme is still running PNC 192988041-B-362011