Electrolux EWP 106100 W, EWP 126100 W, EWP 86100 W Installation, Unpacking, Necessary tools

Page 6

6electrolux

Spin Speed		Maximum

1) Connect the water inlet hose to a water tap with a 3/4'' thread.

800 rpm (EWP86100W)

1000 rpm (EWP106100W)

1200 rpm (EWP126100W)

INSTALLATION

UNPACKING

Warning!

•Read carefully the "Safety informa- tion" chapter before installing the ap- pliance.

Warning! Remove and keep all transit devices so that they can be refitted if the appliance ever has to be transported again.

sure that no hoses are crushed in the process.

	x 3
A	B x 3

•Remove the polystyrene base from the bottom.

C

x 1

1

x 2

Necessary tools 1)

10 mm 30 mm

•Remove the external film. Use a cutter, if necessary.

•Remove the cardboard top.

•Remove the polystyrene packaging ma- terials.

•Spread the front piece on the floor be- hind the appliance and then lay the appli- ance carefully rear side down on it. Make

2

• Return appliance to the upright position.

•Open the door and remove the plastic hose guide, the bag containing the in- struction booklet and the plastic plug caps from the drum.

1) These tools are not provided with the appliance.

Image 6

Contents Washing Machine Contents Safety InformationThis appliance must be connected to a cold water supply InstallationChild Safety USEFrost Precaution Environment ConcernsPackaging Materials Technical Data Product DescriptionEcological Hints Installation UnpackingNecessary tools Positioning and Levelling Water Drainage Hooked over the edge of a sink using the plastic hose guideWater Inlet Onto a sink outlet spigotDirectly to a built-in drain pipe in the room wall Connections Overview Special AccessoriesFirst USE Electrical ConnectionBall point pen and glue moisten with Daily USESort OUT the Laundry Before Loading the LaundryQuantity of Detergent to be Used Maximum LoadsClose the Door Gently Detergents and Additives Degrees of Water HardnessUP- Flap position if using Powder de- tergent Flap for Powder or Liquid DetergentFlap is down and you wish to use powder detergent SET Your Washing Programme Measure OUT the Fabric Softener Close the Detergent Dispenser DrawerButton 6 starts flashing the appliance is now Rinse Hold Delay StartSelect a delayed start Extra RinseOpened pay attention to the water level and tem Indicator pilot lightsStart/Pause Start the programme by pressing the button AT the END of the ProgrammeWashing Programmes Door SealSynthetic Spin Cleaning the Dispenser Drawer Care and CleaningMaintenance Wash Consumption ValuesCleaning the Drain Filter Remove the filter and clean it under the tap Cleaning the Water Inlet Filters What to do IF…Malfunction Replace it with a new one Programme is still running PNC 192988041-B-362011