24electrolux
CLEANING THE WATER INLET FILTERS
Important! If the appliance doesn't fill, it takes a long time to fill with water, the starting button flashes red or the display (if available) shows the relevant alarm (see chapter "What to do if..." for more details), check if the water inlet filters are blocked .
To clean the water inlet filters:
•Turn off the water tap.
•Unscrew the hose from the tap.
•Clean the filter in the hose with a stiff brush.
•Screw the hose back onto the tap. Make sure the connection is tight.
•Unscrew the hose from the appliance. Keep a towel nearby because some wa- ter may flow.
•Clean the filter in the valve with a stiff brush or with the piece of cloth.
•Screw the hose back to the appliance and make sure the connection is tight.
•Turn on the water tap.
WHAT TO DO IF…
The appliance does not start or stops dur- ing operation. Certain problems are due to lack of simple maintenance or oversights, which can be solved with the help of the in- dications described in the charts, without calling out an engineer.
During appliance operation it is possible that the red pilot light of the button 6 flash-
es and one of the indicator pilot lights illumi- nates to indicate that the appliance is not working.
Before contacting your local Service Cen- tre, please carry out the checks listed be- low.
Fault code and mal- Possible cause - Solution function
The light of button 6 flashes and the light 7.1 illuminates: Problem with the water supply
The water tap is closed.
• Open the water tap.
The inlet hose is squashed or kinked.
• Check the inlet hose connection.
The filter in the inlet hose or the inlet valve filter are blocked
• Clean the water inlet filters (read "Cleaning the water inlet fil- ters" for more details).
The light of button 6 flashes and the light 7.2 illuminates: Problem with the water drainage