Electrolux EWP 126100 W, EWP 106100 W, EWP 86100 W user manual Malfunction

Page 25

electrolux 25

The drain hose is squashed or kinked.

• Check the drain hose connection. The drain filter is clogged

If the appliance stops working without discharging the water , first carry out an emergency drain:

– Turn the programme selector dial to ;

– Unplug the appliance;

Close the water tap;

If necessary, wait until the water has cooled down;

Unscrew the drain hose from the rear support (see "Frost precaution") and unhook it from the sink or spigot;

Let it run along the floor;

Place a bowl on the floor and place the end of the draining hose into the bowl. The water should drain by gravity into the bowl. When the bowl is full, empty it. Repeat the proce- dure until water stops flowing out ;

Screw the draining hose to the rear support and reposition it;

Open the door and remove the laundry;

Carry out the drain filter cleaning as described in "Cleaning the drain filter";

At the end of cleaning action, close the door and insert the mains plug again;

Run a drain programme to check if the appliance works now.

The light of button 6 flashes and the light 7.3 illuminates: Door open

The door has not been closed or is not closed properly.

• Close firmly the door.

The appliance does not start or stops dur- ing operation without any visible alarm.

Before contacting your local Service Cen- tre, please carry out the checks listed be- low.

Malfunction

The appliance does not start:

Possible cause / Solution

The plug is not properly inserted in the power socket.

Insert the plug into the power socket. There is no power at the socket.

Please check your domestic electrical installation. The main fuse has blown.

Replace the fuse.

The programme selector dial is not correctly positioned and the button 6 has not been pressed.

Please turn the selector dial and press the button 6 again. The delay start has been selected.

If the laundry are to be washed immediately, cancel the delay start.

Image 25
Contents Washing Machine Safety Information ContentsChild Safety InstallationThis appliance must be connected to a cold water supply USEEnvironment Concerns Frost PrecautionPackaging Materials Product Description Technical DataEcological Hints Unpacking InstallationNecessary tools Positioning and Levelling Water Inlet Hooked over the edge of a sink using the plastic hose guideWater Drainage Onto a sink outlet spigotDirectly to a built-in drain pipe in the room wall First USE Special AccessoriesConnections Overview Electrical ConnectionSort OUT the Laundry Daily USEBall point pen and glue moisten with Before Loading the LaundryClose the Door Gently Detergents and Additives Maximum LoadsQuantity of Detergent to be Used Degrees of Water HardnessFlap for Powder or Liquid Detergent UP- Flap position if using Powder de- tergentFlap is down and you wish to use powder detergent Close the Detergent Dispenser Drawer SET Your Washing Programme Measure OUT the Fabric SoftenerButton 6 starts flashing the appliance is now Select a delayed start Delay StartRinse Hold Extra RinseStart/Pause Start the programme by pressing the button Indicator pilot lightsOpened pay attention to the water level and tem AT the END of the ProgrammeDoor Seal Washing ProgrammesSynthetic Spin Maintenance Wash Care and CleaningCleaning the Dispenser Drawer Consumption ValuesCleaning the Drain Filter Remove the filter and clean it under the tap What to do IF… Cleaning the Water Inlet FiltersMalfunction Replace it with a new one Programme is still running PNC 192988041-B-362011