Electrolux EWP 126100 W, EWP 106100 W, EWP 86100 W user manual Positioning and Levelling

Page 7

electrolux 7

•Remove the power supply cable and the draining and inlet hose from the hose holders (C) on the rear of the appliance.

•Unscrew the three bolts (A) and remove the hose holders (C).

•Slide out the relevant plastic spacers (B).

Warning! Do not remove the drain hose from the rear support. Remove this hose only if it is necessary to drain the water. Refer to "Frost precaution" and "What to do if".

•Plug the smaller upper hole and the two large ones with the corresponding plastic plug caps.

POSITIONING AND LEVELLING

Level the appliance by raising or lowering the feet. Depending on the model, the ap- pliance can have four adjustable feet, or two front-adjustable feet and two back fixed feet.

The appliance MUST be level and stable on a flat hard floor. If necessary, check the set- ting with a spirit level. Any necessary ad- justment can be made with a spanner.

Image 7

Contents Washing Machine Safety Information ContentsUSE InstallationChild Safety This appliance must be connected to a cold water supplyEnvironment Concerns Frost PrecautionPackaging Materials Product Description Technical DataEcological Hints Unpacking InstallationNecessary tools Positioning and Levelling Onto a sink outlet spigot Hooked over the edge of a sink using the plastic hose guideWater Inlet Water DrainageDirectly to a built-in drain pipe in the room wall Electrical Connection Special AccessoriesFirst USE Connections OverviewBefore Loading the Laundry Daily USESort OUT the Laundry Ball point pen and glue moisten withDegrees of Water Hardness Maximum LoadsClose the Door Gently Detergents and Additives Quantity of Detergent to be UsedFlap for Powder or Liquid Detergent UP- Flap position if using Powder de- tergentFlap is down and you wish to use powder detergent Close the Detergent Dispenser Drawer SET Your Washing Programme Measure OUT the Fabric SoftenerButton 6 starts flashing the appliance is now Extra Rinse Delay StartSelect a delayed start Rinse HoldAT the END of the Programme Indicator pilot lightsStart/Pause Start the programme by pressing the button Opened pay attention to the water level and temDoor Seal Washing ProgrammesSynthetic Spin Consumption Values Care and CleaningMaintenance Wash Cleaning the Dispenser DrawerCleaning the Drain Filter Remove the filter and clean it under the tap What to do IF… Cleaning the Water Inlet FiltersMalfunction Replace it with a new one Programme is still running PNC 192988041-B-362011