electrolux 17
Important! The selected delay can be changed only after selecting the washing pro- gramme again. The door will be locked throughout the delay time. If you need to open the door, you must set the appliance to PAUSE (by pressing the button 6) and then wait a few minutes. After you have closed the door, press the button 6 again.
6 |
| Start/Pause | Start the programme by pressing the button 6 |
|
|
| • To start the selected programme, press the button 6, |
|
|
| the corresponding green pilot light stops flashing. The |
|
|
| pilot light 7.1 illuminates to indicate that the appliance |
|
|
| starts operating and the door is locked. If you have |
|
|
| chosen a delayed start, the appliance will begin the |
|
|
| countdown. |
|
|
| • To interrupt a programme which is running, press the |
|
|
| button 6: the corresponding green pilot light starts |
|
|
| flashing. It is possible to change some options of a |
|
|
| running programme before the programme carries |
|
|
| them out. |
|
|
| • To restart the programme from the point at which it |
|
|
| was interrupted, press the button 6. |
|
|
| • After the programme has started the door is locked. If, |
|
|
| for any reason, you need to open the door, set firstly |
|
|
| the appliance to PAUSE by pressing the button 6. Af- |
|
|
| ter a few minutes it will be possible to open the door. |
|
|
| If the door remains locked, this means that the appli- |
|
|
| ance is already heating or that the water level is too |
|
|
| high. In any case, do not try to force the door! |
|
|
| If you cannot open the door but you need to open it |
|
|
| you have to switch the appliance off by turning the se- |
|
|
| lector dial to . After a few minutes the door can be |
|
|
| opened (pay attention to the water level and tem- |
|
|
| perature!). After closing the door, it is necessary to |
|
|
| select the programme and options again and to press |
|
|
| the button 6. |
|
| Indicator pilot lights | • When you start the programme by pressing the button |
|
|
| 6, the washing phase pilot light (7.1) illuminates. This |
7.1 |
| means that the appliance is operating. | |
|
|
| • The additional rinses pilot light (7.2) illuminates when |
|
| the appliance performs an extra rinse. | |
7.2 |
| ||
|
|
| • When the programme has finished the end cycle pilot |
| light (7.3) comes on. | |
7.3 | ||
|
AT THE END OF THE PROGRAMME
The appliance stops automatically. The pilot light of the button 6 and the pilot light cor- responding to the just finished washing phase go off. The light 7.3 illuminates.
If a programme or an option that ends with water left in the tub has been selected and the door remains locked to indicate that the water must be emptied out before opening the door.
Follow the below instructions to empty out the water:
•Turn the programme selector dial to 
.
•Select the draining or spinning pro- gramme.
•Reduce the spin speed if needed, by pressing the relevant button.
•Press the button 6.