Selecting the FM reception mode

Tuner operations

3Press the numeric buttons (1 – 10, +10) to select a channel number while the channel number position is flashing.

•For channel number 5, press 5.

•For channel number 15, press +10, then 5.

•For channel number 30, press +10, +10, then 10.

ANALOG L	R	TUNED ST AUTO MUTING
SUBWFR		MHZ
		VOL

4Press MEMORY again while the selected channel number is flashing on the display.

The station is assigned to the selected channel number.

• The selected channel number stops flashing.

ANALOG L	R	TUNED ST AUTO MUTING

SUBWFR		MHZ
		VOL

5Repeat steps 1 to 4 until you store all the stations you want.

To erase a stored preset station

Storing a new station on a used channel number erases the previously stored one.

On the front panel:

SOURCE SELECTOR

MASTER VOLUME

DIMMER

SETTING

ADJUST

SURROUND

SET / TUNER PRESET

/ MULTI JOG

PHONES

STANDBY / ON

STANDBY

DVD MULTI

DVD

DBS

VCR

FM / AM

Before you start, remember...

There is a time limit in doing the following steps. If the setting is

canceled before you finish, start from step 2 again.

1Turn SOURCE SELECTOR to select “FM” or “AM.”

The last received station of the selected band is tuned in.

2Press TUNER PRESET.

“P” appears on the display and MULTI JOG now works for selecting preset channels.

3Turn MULTI JOG to select a preset channel number during “P” appears on the display.

•Turning MULTI JOG clockwise increases the preset channel numbers.

•Turning MULTI JOG counterclockwise decreases the preset channel numbers.

ANALOG L	R	TUNED ST AUTO MUTING

SUBWFR		MHZ
		VOL

To tune in a preset station

From the remote control:

1Press FM/AM to select the band.

The last received station of the selected band is tuned in and the numeric buttons now work for tuner operations.

•Each time you press the button, the band alternates between FM and AM.

ANALOG L	R	TUNED ST AUTO MUTING

SUBWFR		MHZ
		VOL

2Press the numeric buttons (1 – 10, +10) to select a channel number.

If you select “FM” or “AM” using SOURCE SELECTOR on the front panel, press FM/AM on the remote control before this operation.

•For channel number 5, press 5.

•For channel number 15, press +10, then 5.

•For channel number 30, press +10, +10, then 10.

ANALOG L	R	TUNED ST AUTO MUTING

SUBWFR		MHZ
		VOL

When an FM stereo broadcast is hard to receive or noisy, you can change the FM reception mode while receiving an FM broadcast.

•You can store the FM reception mode for each preset station (see page 24).

From the remote control ONLY:

While listening to an FM station, press FM MODE.

If you select “FM” using SOURCE SELECTOR on the front panel, press FM/AM on the remote control before this operation.

•Each time you press the button, the FM reception mode alternates between “AUTO MUTING” and “MONO.”

AUTO MUTING*:	Normally select this.
	When a program is broadcast in stereo, you
	will hear stereo sound; when in monaural, you
	will hear monaural sound. This mode is also
	useful to suppress static noise between
	stations. The AUTO MUTING indicator lights
	up on the display.

MONO:	Select this to improve the reception (but
	stereo effect will be lost).
	In this mode, you will hear noise while tuning
	in to the stations. The AUTO MUTING
	indicator goes off from the display. (The ST
	indicator also goes off.)

* Initial setting