Getting started
Precautions
General precautions
•DO NOT disassemble the unit or remove screws, covers, or cabinet.
•DO NOT expose the unit to rain or moisture.
•DO NOT expose the unit to direct sunlight or place it near a heating device.
Locations
•Install the receiver in a location that is level and protected from moisture and dust.
If water gets inside the unit, turn off the power and remove the plug from the outlet, then consult your dealer. Using the unit in this state may cause a fire or electrical shock.
•Select a place which is level, dry and neither too hot nor too cold between 5˚C and 35˚C
•Make sure there is good ventilation around the receiver. Poor ventilation could cause overheating and damage the receiver.
•Leave sufficient distance between the unit and the TV.
•Do not install the unit in a place subject to vibrations.
Handling the receiver
•DO NOT touch the power cord with wet hands.
•DO NOT pull on the power cord to unplug the cord. When unplugging the cord, always grasp the plug so as not to damage the cord.
•Keep the power cord away from the connecting cords and the antenna. The power cord may cause noise or screen interference. It is recommended to use a coaxial cable for antenna connection, since it is
•When a power failure occurs, or when you unplug the power cord, the preset settings such as preset FM or AM channels and sound adjustments may be erased in a few days.
•When you are away on travel or otherwise for an extended period or time, remove the plug from the wall outlet. A small amount of power is always consumed while the power cord is connected to the wall outlet.
To prevent the malfunction
•There are no
•Do not insert any metallic objects, such as wires, hairpins, coins, etc. into the unit.
•Do not block the vents. Blocking the vents may damage the unit.
To clean the cabinet
•Use a soft cloth. Follow the relevant instructions on the use of
•Do not use benzene, thinner or other organic solvents and disinfectants. These may cause deformation or discoloring.
Putting batteries in the remote control
Before using the remote control, put two supplied batteries first.
•When using the remote control, aim the remote control directly at the remote sensor on the front panel.
1 Press and slide the battery cover on the back of the remote control.
2 Insert batteries.
Make sure to match the polarity:
(+) to (+) and
3 Replace the cover.
If the range or effectiveness of the remote control decreases, replace the batteries. Use two
• Supplied butteries are for initial setup. Replace for continued use.
CAUTION:
Follow these precautions to avoid leaking or cracking cells:
•Place batteries in the remote control so they match the polarity:
(+) to (+) and
•Use the correct type of batteries. Batteries that look similar may differ in voltage.
•Always replace both batteries at the same time.
•Do not expose batteries to heat or flame.
Setting the voltage selector (RX-ES1SL)
Before connections, always do the following first if necessary. Select the correct voltage in VOLTAGE SELECTOR on the rear of the receiver by using a screw driver. Check to be sure if the voltage mark is set to the voltage for your area where this unit plugs in.
Checking the supplied accessories
Check to be sure you have all of the following supplied accessories. The number in parentheses indicates the quantity of each piece supplied.
VOLTAGE SELECTOR
220V 
110V
•Remote control (1)
•Batteries (2)
•AM loop antenna (1)
•FM antenna (1)
•Digital coaxial cord (1)
•Audio/video cord (1)
Voltage mark
230 -
240V
127V
If anything is missing, contact your dealer immediately.
5