JVC LVT1002-012B Specifications, Audio, Video, Dvd, Dvd Multi, Dbs, Vcr, Tv, Dvd, Dbs, Vcr, Tv

Page 76

Specifications

Designs & specifications are subject to change without notice.

RX-ES1SL

Amplifier

Output Power

At stereo operation:
Front channels:	100 W per channel*, min. RMS, driven into
	8 Ω at 1 kHz with no more than 0.8% total
	harmonic distortion. (IEC268-3)
At surround operation:
Front channels:	100 W per channel*, min. RMS, driven into
	8 Ω at 1 kHz with no more than 0.8% total
	harmonic distortion.
Center channel:	100 W*, min. RMS, driven into 8 Ω at 1 kHz,
	with no more than 0.8% total harmonic
	distortion.
Surround channels: 100 W per channel*, min. RMS, driven into
	8 Ω at 1 kHz, with no more than 0.8% total
	harmonic distortion.
*Measured on AC 110V, 127 V, 220 V and 240 V.

Audio

Audio Input Sensitivity/Impedance (1 kHz):

DVD, DVD MULTI, DBS, VCR, TV:

	260 mV/47 kΩ
Audio Input (DIGITAL IN)* :
Coaxial: DIGITAL 1 (DVD):	0.5 V(p-p)/75 Ω

Optical: DIGITAL 2/3 (DBS/TV):

–21 dBm to –15 dBm (660 nm ±30 nm)

*Corresponding to Linear PCM, Dolby Digital, and DTS Digital Surround (with sampling frequency—32 kHz, 44.1 kHz, 48 kHz).

Audio Output Level: VCR:	250 mV
Signal-to-Noise Ratio (’66 IHF/DIN):
DVD MULTI:	87 dB/62 dB
Frequency Response (8 Ω):
DVD, DBS, VCR, TV:	20 Hz to 20 kHz (±1 dB)
Tone Control:
Bass (100 Hz):	±10 dB ±2 dB
Treble (10 kHz):	±10 dB ±2 dB
Bass Boost:	+4 dB ± 1 dB at 100 Hz

Video

Video Input Sensitivity/Impedance (1 kHz):

Composite video:DVD, DBS, VCR:

	1 V(p-p)/75 Ω
S-Video:DVD, DBS, VCR:
(Y:luminance):	1 V(p-p)/75 Ω
(C:chrominance):	0.286 V(p-p)/75 Ω
Component video:DVD, DBS:
(Y:luminance):	1 V(p-p)/75 Ω
(PB/PR):	0.7 V(p-p)/75 Ω

Video Output Level/Impedance (1 kHz):

Composite video: VCR, MONITOR OUT:

	1 V(p-p)/75 Ω
S-Video: VCR, MONITOR OUT:
(Y:luminance):	1 V(p-p)/75 Ω
(C:chrominance):	0.286 V(p-p)/75 Ω
Component video: MONITOR OUT:
(Y:luminance):	1 V(p-p)/75 Ω
(PB/PR):	0.7 V(p-p)/75 Ω
Synchronize:	Negative

FM tuner (IHF)

Tuning Range:	87.50 MHz to 108.00 MHz
Usable Sensitivity:
Monaural:	12.8 dBf (1.2 µV/75 Ω)
50 dB Quieting Sensitivity:
Monaural:	16.0 dBf (1.7 µV/75 Ω)
Stereo:	37.5 dBf (20.5 µV/75 Ω)
Stereo Separation at REC OUT:	35 dB at 1 kHz

AM tuner

Tuning Range: 522 kHz to 1 629 kHz

General

Power Requirements:	AC 110 V/127 V/220 V/230 V – 240 V,
	adjustable with the voltage selector,
	50 Hz/60 Hz
Power Consumption:	100 W (at operation)
	5 W (in standby mode)
Dimensions (W x H x D):	435 mm x 69.5 mm x 330.5 mm
Mass:	6.5 kg

73

Image 76

Contents RX-ES1SL XV-NK58SL Important for Laser Products XV-NK58SL RX-ES1SLDo not stack RX-ES1SL and XV-NK58SL Table of Contents Remote control Parts identificationParts identification Front panelDisplay window Rear panelVIDEO, S-VIDEO, Component Video Signal Selector 9 NTSC, PAL Rear panelFront panel COAXIAL, OpticalPrecautions Putting batteries in the remote controlSetting the voltage selector RX-ES1SL Checking the supplied accessoriesGetting started Connecting the FM and AM antennasFM antenna connection Connecting the speakers and DVD player Speaker Layout DiagramConnecting the subwoofer Connecting the front, center, and surround speakersConnecting the DVD player XV-NK58SL Supplied 1 cableConnecting other video components TV connectionVCR connection Picture SourceDBS tuner connection Analog connection for DVD Multi playback seeConnecting the power cord Digital connectionTurn on the power To turn off the power into standbySelecting the analog or digital input mode Basic operationsSelecting the digital decode mode Adjust the volumeListening with headphones Headphone modeTurning off the power with the Sleep Timer Basic adjustment of auto memorySignal and speaker indicators on the display Turning off the sounds temporarily- MutingSpeaker settings From the remote control onlySetting UP flashes on the display Before you start, rememberSpeaker settings When selecting Medium Room When selecting Large RoomYour setting is stored Register the sizes of all the connected speakersSetting the speaker delay time Crossover frequency is not valid for the Headphone modeBasic settings Operating procedureSetting the digital input Digital Terminals-DIGITALSetting the video component input mode-DVD VIDEO/DBS Video Setting Auto Surround-AUTO SRBasic settings Sound adjustments Adjusting the subwoofer output levelAdjusting the tone-BASS, Treble Press AdjustAdjusting the front speakers output balance-BAL Attenuating the input signal-ATTSound adjustments When using the remote control Press Bass BoostTuning in to stations manually Using preset tuningFrom the remote control only Press FM/AM to select the band Tuner operationsTo tune in a preset station Selecting the FM reception modeTuner operations Creating realistic sound fields Reproducing theater ambienceIntroducing the Surround/DSP modes Surround modesDSP Digital Signal Processor modes Creating realistic sound fieldsDAP Digital Acoustic Processor modes All Channel StereoUsing Surround modes Press Surround to select an appropriate Surround modeFrom the remote control Select and play software you likeTurn Multi JOG to select an appropriate Surround mode Press Test to check the speakers output balancePress Test again to stop the test tone Press SurroundUsing DSP modes Repeat steps 5 and 6 to adjust the other settingsFrom the remote control To cancel Surround modeTo cancel DSP Modes To adjust the DAP effect levelEffect available only for DAP modes *2 Using the DVD Multi playback mode Adjusting the speaker output levelActivating the DVD Multi playback mode From the remote control Press DVD MultiAbout this manual Before operationAbout discs Initial setup Turning on/off the playerPress Enter Press 5/∞ to select the desired languageIf a menu is shown on the TV screen Basic playbackAbout PBC Playback Control Resuming playback Various speed playback To resume playbackTo advance or reverse playback rapidly while monitoring X1.5 Quick Playback with soundUsing the numeric buttons Locating the beginning of a scene or songTo play back in slow motion To replay the previous scenes One touch replay functionAdvanced operations Playing from a specific positionLocating a desired scene from the DVD menu Specifying a desired titleChanging the playback order To play back in a specific order Program playAdvanced operations To dismiss the menu barTo play back in random order Random play Repeat playback To repeat a desired part A-B repeat playbackTo stop repeat playback To quit repeat playbackTo change the audio language or sound Audio Changing the language, sound and scene angleTo select a scene angle of DVD Video Angle To adjust the picture character VFP Special picture/sound effectTo zoom in pictures To return to the normal playbackBasic operation procedure Menu bar functionsTo simulate surround sound 3D Phonic To bring up the menu barTime mode selection Menu bar functions for DVD VideoMenu bar functions for SVCD/Video CD/ Audio CD CHAP. Chapter searchMP3/WMA disc playback OperationsAbout MP3/WMA discs Basic operationsDirect selection Repeat playbackMP3/WMA disc playback Jpeg disc playback About Jpeg discsBasic operations To see a desired pictureViewing pictures continuously slide show mode To zoom in the pictureTo start the slide show To select the start point of the slide showPress Repeat mode remains active Repeat functionWhile the Jpeg Control display is shown, press Repeat Press 3 to start repeat playbackPreparation Karaoke operationReserving songs Selecting audio track Audio Selecting audioKaraoke operation Selecting Karaoke sound Karaoke Example for SVCD, Video CD or Audio CD withKaraoke +R Stereo audio Left channel only Right channel onlyUsing the Effect button Adding an effect to your voiceAdding various effects to the vocal Vocal Adding an echo effect EchoUsing the KEY 9/KEY buttons Adjustable range is from -4 to +4Shifting the musical key Press KEY 9 or KEYChanging the initial settings How to set preferencesSelecting preferences About the Preference displayLanguage menu Changing the initial settingsPicture menu Audio menu Others menuLimiting playback by children To set Parental Lock for the first timeBring up the Others menu Press 5/∞ to move To select Parental Lock then press EnterTo change the settings To temporarily release the Parental LockPress 5/∞ to move To select Parental Lock and press Enter Press 5/∞ to move to Temporary RELEASE, then press EnterAppendix a Country/Area code list for Parental Lock Additional informationAppendix C Digital output signal chart Appendix B Table of languages and their abbreviationsAdditional information Output Disc typeAppendix D Glossary AV Compu Link remote control system Connections 1 AV Compu Link ConnectionConnections 2 Video Cable Connection Monaural mini-plugsAV Compu Link remote control system Automatic selection of TV’s input modeAutomatic power On/Off One-touch video playOperating other JVC products DVD playerOperating other manufacturers’ equipment Try to operate your DBS tuner by pressing DBSManufacturer Codes DBSChanging the transmittable signals for operating a Changing the transmittable signals for operating aOperating other manufacturers’ equipment Try to operate your VCR by pressing VCRProblem Possible Cause Solution TroubleshootingGeneral Surround/DSP TroubleshootingFM/AM Video Active AudioStandard Jpeg KaraokeSpecifications AudioVideo DVD, DVD MULTI, DBS, VCR, TVSpecifications 220V 230 240V  2003 Victor Company of JAPAN, Limited 0603NHMMDWJEIN