JVC LVT1002-001B manual Getting started, Precautions, Checking the supplied accessories

Getting started

Precautions

General precautions

•DO NOT disassemble the unit or remove screws, covers, or cabinet.

•DO NOT expose the unit to rain or moisture.

•DO NOT expose the unit to direct sunlight or place it near a heating device.

Locations

•Install the receiver in a location that is level and protected from moisture and dust.

If water gets inside the unit, turn off the power and remove the plug from the outlet, then consult your dealer. Using the unit in this state may cause a fire or electrical shock.

•Select a place which is level, dry and neither too hot nor too cold between 5˚C and 35˚C

•Make sure there is good ventilation around the receiver. Poor ventilation could cause overheating and damage the receiver.

•Leave sufficient distance between the unit and the TV.

•Do not install the unit in a place subject to vibrations.

Handling the receiver

•DO NOT touch the power cord with wet hands.

•DO NOT pull on the power cord to unplug the cord. When unplugging the cord, always grasp the plug so as not to damage the cord.

•Keep the power cord away from the connecting cords and the antenna. The power cord may cause noise or screen interference. It is recommended to use a coaxial cable for antenna connection, since it is well-shielded against interference.

•When a power failure occurs, or when you unplug the power cord, the preset settings such as preset FM or AM (MW) channels and sound adjustments may be erased in a few days.

•When you are away on travel or otherwise for an extended period or time, remove the plug from the wall outlet. A small amount of power is always consumed while the power cord is connected to the wall outlet.

To prevent the malfunction

•There are no user-servicable parts inside. If anything goes wrong, unplug the power cord and consult your dealer.

•Do not insert any metallic objects, such as wires, hairpins, coins, etc, into the unit.

•Do not block the vents. Blocking the vents may damage the unit.

To clean the cabinet

•Use a soft cloth. Follow the relevant instructions on the use of chemically-coated cloths.

•Do not use benzene, thinner or other organic solvents and disinfectants. These may cause deformation or discoloring.

Checking the supplied accessories

Check to be sure you have all of the following supplied accessories. The number in parentheses indicates the quantity of each piece supplied.

•Remote control (1)

•Batteries (2)

•AM (MW) loop antenna (1)

•FM antenna (1)

•SCART cable (1)

•Digital coaxial cord (1)

•Audio video cord (yellow/red/white) (1)

—not for using with RX-ES1SL

If anything is missing, contact your dealer immediately.

Putting batteries in the remote control

Before using the remote control, put two supplied batteries first.

1 Press and slide the buttery cover on the bac k of the remote control.

2 Insert batteries.

Make sure to match the polarity:

(+) to (+) and (–) to (–).

3 Replace the co ver.

If the range or effectiveness of the remote control decreases, replace the batteries. Use two R6P(SUM-3)/AA(15F) type dry-cell batteries.

•Supplied butteries are for initial setup. Replace for continued use.

CAUTION:

Follow these precautions to avoid leaking or cracking cells:

•Place batteries in the remote control so they match the polarity:

(+) to (+) and (–) to (–).

•Use the correct type of batteries. Batteries that look similar may differ in voltage.

•Always replace both batteries at the same time.

•Do not expose batteries to heat or flame.

When using the remote control, aim the remote control directly at the remote sensor on the front panel.

RX-ES1SL

Remote sensor

XV-N55SL

Remote sensor

5