Whirlpool W10120482A Recessed Area and Closet Installation Instructions, Product Dimensions

Page 5

Recessed Area and Closet Installation Instructions

This dryer must not be installed behind a lockable door, a sliding door, or a door with a hinge on the opposite side to that of the dryer.

Product Dimensions

Dimensions shown with feet extended 2.5 cm (1") from bottom of dryer.

This dryer may be installed in a recessed area or closet. For recessed area and closet installations, minimum clearances can be found on the serial tag on the dryer.

The installation spacing is in centimeters (inches) and is the minimum allowable. Additional spacing should be considered for ease of installation, servicing, and compliance with local codes and ordinances.

If closet door is installed, the minimum unobstructed air opening in the top and bottom is required. Louvered doors with equivalent air openings are acceptable.

The dryer must be exhausted outdoors.

No other fuel-burning appliance may be installed in the same closet as the dryer.

Minimum Installation Clearances

27.9 cm

(11")

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

109.5 cm

 

 

 

 

(43-1/8")

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

97.2

cm

 

3.8 cm

 

 

 

(38-1/4")

 

 

(1-1/2")

 

 

 

 

 

 

gas line

 

 

 

 

 

 

 

 

 

 

 

 

opening

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

An electrical outlet is required within 1.4 m (4-1/2 feet) for the power supply cord

35.6 cm (14") door clearance

15.9 cm (6-1/4")

 

35.6 cm

 

(14") max.

45.7 cm

Closet

(18")*

door

 

10.2 cm

2.5 cm (1")

(4")

2.5 cm (1")

 

2.5 cm (1")

Recessed front view

Closet side view

Additional clearances for wall, door and floor moldings may be required or if external exhaust elbow is used.

74.3cm (29-1/4")

68.6 cm (27")

Exhaust dimensions

310cm2

(48"2)

Front

View

155cm2

(24"2)

7.6 cm (3")

closet

door

7.6 cm (3")

10.2 cm (4")

35.9 cm

(14-1/8")

back

exhaust

10.8 cm (4-1/4")

26 cm

(10-1/4")

left or right side exhaust

*Opening is the minimum for a closet door.

Louvered doors with equivalent air openings are acceptable.

5

Image 5
Contents W10120482A Dryer Safety Table of ContentsWhat to do if YOU Smell GAS Location Requirements Installation RequirementsTools and Parts Minimum Installation Clearances Recessed Area and Closet Installation InstructionsProduct Dimensions Gas Requirements Electrical RequirementsVenting Requirements Maximum Vent Length Vent System LengthRigid Metal Vent Flexible Metal VentPrepare Dryer Installation Instructions GAS DryerInstall Ventwork Level and Exhaust the Dryer Check Operation Technical SpecificationSeguridad DE LA Secadora ÍndicePasos QUE Usted Debe Seguir SI Huele a GAS Requisitos de ubicación Requisitos DE InstalaciónPiezas y herramientas Espacios mínimos para la instalación Instrucciones para la instalación empotrada o en clósetMedidas del producto Requisitos del suministro de gas Requisitos eléctricosRequisitos de ventilación Longitud máxima del ducto de escape Largo del sistema de ventilaciónDucto de escape de metal rígido Ducto de escape de metal flexiblePreparación de la secadora Instalación de la ventilaciónNivelación y ventilación de la secadora Especificaciones técnicas Verifique el funcionamientoSecurite DU SECHE-LINGE Table DES MatieresQUE Faire Dans LE CAS D’UNE Odeur DE GAZ Outillage et pièces Exigences DinstallationExigences demplacement Dégagements de séparation minimums Dimensions de lappareilExigences concernant lalimentation en gaz Spécifications électriquesExigences concernant l’évacuation Longueur maximale du conduit Longueur du système d’évacuationConduit métallique rigide Conduit métallique flexiblePréparation du sèche-linge Installation du dispositif d’évacuationMise à niveau et évacuation du sèche-linge Caractéristiques techniques Contrôle du fonctionnementW10120482 AImpreso en EE.UU. Imprimé aux E.-U 2007 01/2007