INSTALLATION INSTRUCTIONS – GAS DRYER
Install Ventwork
1.Install exhaust hood. Use sealing compound to seal exterior wall opening around exhaust hood.
2.Connect exhaust vent to hood. (Exhaust vent MUST fit inside hood.) Secure vent to hood with a 100 mm (4") clamp.
3.Run exhaust vent to dryer location. Use the straightest path possible. Avoid 90° turns. Use 100 mm (4") clamps to secure vent peices. Tin snips may be needed to cut vent to required length.
2.Take two cardboard corners from dryer carton and place them on floor in back of dryer. Firmly grasp body of dryer and gently lay it on its back on the cardboard corners.
3.Start to screw legs into holes by hand. Use an adjustable wrench or 2.5 cm (1")
Prepare Dryer
WARNING
Excessive Weight Hazard
Use two or more people to move and install dryer. Failure to do so can result in back or other injury.
1.Remove tape from dryer cabinet. Open dryer door and remove tape from dryer drum. (Not all dryer drums are taped.) Remove drying rack, if included. Turn dryer drum counterclockwise to make sure all tape was removed. Wipe drum with damp cloth to remove any dust.
diamond marking
4.Stand dryer up on cardboard or hardboard.
9