Whirlpool 8535845 installation instructions Dura Safe, Check operation

G. Check operation

Check that you:

✔did not skip any steps.

✔installed all parts.

✔properly installed dryer legs.

✔leveled dryer.

✔have secured all exhaust vent joints with 4” clamps.

✔have all the tools you started with.

Plug power supply cord into grounded outlet. Turn power supply on.

Read the Use and Care Guide to fully understand your new dryer. Select a

full heat cycle (not the air cycle) and start dryer. After five minutes, open dryer door. You should feel heat inside dryer.

If the burner did not ignite and you do not feel heat inside the dryer, shut the dryer off for 5 minutes. Then check that:

✔controls are set in a running or “On” position.

✔start button has been pushed firmly.

✔gas supply line shutoff valve is open.

Repeat 5-minute test. If dryer still does not operate properly, check the following:

✔electrical supply is connected.

✔house fuse is intact and tight; or circuit breaker has not tripped.

✔dryer door is closed.

If dryer makes an unusual noise, check that dryer is level.

CRUSH	TM
RESISTANT
	Dura Safe
SURE CONNECTTM Vent Kit
Kits Make Installation Easy

Periscopes For Offset

Outlets, Tight Installations

For more information, or to have your venting professionally installed, call the Consumer Assistance Center. Check your Use and Care Guide for a toll-free

◆ Provides 4 1/2"

clearance between

dryer and wall

◆ Snap-Lock fittings

◆ Total kit length 8 feet

◆ Additional vent can

be snapped between

sections for

◆Provides 2 1/2" clearance between dryer and wall

◆Great for closet installations

◆0"-18", 18"-29" or 29"-50" periscopes include one male snap-lock fitting, one extra

long draw-band collar and one clamp

2 1/2"

21/2"

0"-18" : Part #4396037

18"-29" : Part #4396011

29"-50" : Part #4396014

number to call or call the dealer from whom you purchased this appliance. The dealer is listed in the Yellow Pages of your phone directory under “Appliances

— Household — Major — Service and Repair.”

Part #4396028 longer runs

Kit Contains:

2 - 4' vent sections with attached close elbows

1 - Wall plate for close clearance installations

2 - 4" clamps

.

Dura Safe and Sure Connect are Trademarks of Whirlpool, U.S.A.

0"-18" Periscope

◆ Use when vent outlets overlap or are offset

◆Excess length can

be trimmed to fitPart #4396037

18"-29" and 29"-50" Periscope

		Sections separate,
Swivel collar		fittings can face
		same or opposite
wall connection
Telescoping		Swivel collar
sections
		Extra long
Beveled edges		band-clamp
		for dryer
allow corner
		connection
installations
18"-29" : Part #4396011	29"-50" : Part #4396014

11