INSTALLATION INSTRUCTIONS
1.Disconnect power.
2.Remove
3. Attach a | |
| the hole below terminal block opening. |
| Strain relief should have a tight fit with |
| dryer cabinet and be in a horizontal |
| position. Put the power supply cord |
| through the strain relief. |
4. | Loosen or remove terminal block screws. |
| Connect the neutral wire (white or center) |
| of power supply cord under the center |
| screw of the terminal block. |
5. | Connect the other two wires to outer |
| terminal block screws. Tighten all terminal |
| block screws firmly. |
6. Tighten the strain relief screws. |
Terminal block cover
External ground connector
Neutral ground- ing wire (green/yellow)
Hold-down screw
Center
Neutral wire (white)
3⁄4 ",
7. Insert tab of terminal block cover into slot |
of the dryer rear panel. Secure cover with |
NOTE: If local codes do not permit the connection of a
3-Wire Connection with
Frame-Grounding Conductor
10