Whirlpool 240-volt installation instructions White

INSTALLATION INSTRUCTIONS

2.Remove hold-down screw and terminal block cover.

3.Attach a 3⁄4-inch, U.L.-listed, strain relief to the hole below terminal block opening. Strain relief should have a tight fit with dryer cabinet and be in a horizontal position. Put the direct wire cable through the strain relief.

Terminal block cover

External ground connector

Neutral grounding wire (green/yellow)

Hold-down screw

Center silver-colored terminal block screw

Neutral wire

(white)

3⁄4 ", U.L.-listed, strain relief

4.Loosen or remove terminal block screws. Connect the neutral wire (white or center) of direct wire cable under the center screw of the terminal block.

•Place the hook-shaped end of the wire over the terminal block screw. The open side of the hook should face to the right. Squeeze hook end of wire together to form a loop.

3-Wire Connection with Direct Wire and Frame-Grounding Conductor

12