Whirlpool 240-volt installation instructions Wire Connection with Frame-Grounding Conductor

1.Disconnect power.

2.Remove hold-down screw and terminal block cover.

3.Attach a 3⁄4-inch, U.L.-listed, strain relief to the hole below terminal block opening. Strain relief should have a tight fit with dryer cabinet and be in a horizontal position. Put the power supply cord through the strain relief.

4.Remove the center terminal block screw. Remove the neutral grounding wire (green/yellow wire) from external grounding screw.

INSTALLATION INSTRUCTIONS

Terminal block cover Hold-down screw

External ground	Center silver-colored
connector	terminal block screw

5.Connect neutral grounding wire and the neutral wire (white) of power supply cord under the center screw of terminal block.

6.Connect the other two insulated wires to outer terminal block screws.

7.Connect the green, grounding wire from the power supply cord to the external grounding conductor screw. Tighten all terminal block screws firmly.

8.Tighten the strain relief screws.

9.Insert tab of terminal block cover into slot of the dryer rear panel. Secure cover with hold-down screw.

Green/yellow wire of harness

External	Center silver-colored	Neutral wire
	terminal block screw
ground		(white)
connector

Green wire	Neutral ground-
of power supply
	ing wire
cord or bare
	(green/yellow)
copper wire	3⁄4”, U.L.-listed,
	strain relief

4-Wire Connection with

Frame-Grounding Conductor

15