JVC GVT0150-008UG, GVT0150-008UX, GVT0150-008US manual This page is except for TH-C9, Connections

Connections

Do not connect the power cord until all other connections have been made.

This page is except for TH-C9.

Note that the illustration below is for SP-PWC6.

Before connecting the speaker cords;

Twist and pull the insulation coat off and remove.

Powered subwoofer

TH-C6: SP-PWC6

TH-C3: SP-PWC3

CAUTION:

SPEAKER IMPEDANCE

4Ω 16Ω

Front speakers

TH-C6: SP-THC6F

TH-C3: SP-THC3F

Speaker cord

•Connect the black cords to the black (r) terminals.

•Connect the white cords to the (q) terminals referring to the table below:

FRONT SPEAKERS (LEFT)	White
FRONT SPEAKERS (RIGHT)	Red
CENTER SPEAKER	Green
SURROUND SPEAKERS (LEFT)	Blue
SURROUND SPEAKERS (RIGHT)	Gray

Surround speakers

Center speaker TH-C6: SP-THC6C TH-C3: SP-THC3C

TH-C6: SP-THC6S

TH-C3: SP-THC3S

CAUTION

•When you connect speakers other than the supplied ones, use speakers of the same speaker impedance (SPEAKER IMPEDANCE) indicated near the speaker terminals on the rear of the powered subwoofer.

•DO NOT connect more than one speaker to one speaker terminal.

Precautions for daily use

•When moving the speakers, do not pull the speaker cords; otherwise, the speakers may fall over, causing damage or injury.

•Do not reproduce sounds at so high a volume that they are distorted; otherwise, the speakers may be damaged by internal heat buildup.

(For TH-C6)

•When holding a speaker, always grasp the lower portion.

•Do not lean against the speakers, as the speakers could fall down or break, possibly causing an injury. Especially be careful that children do not lean against them.

12