Advanced operations
See page 26 for button locations.
Sound and other settings
IMPORTANT
Before using the remote control for the following operation;
• Set the remote control mode selector to
AUDIO.
NOTE
Before you start operation;
•There is a time limit when doing the following steps. If the setting is cancelled before you finish, start from step 1 again.
1 Press SETTING.
Example:
D E C. A / P C M
2 Press Cursor Y/5 to select the item you want to set.
•DEC (Decode):
When you play an external source (DBS D is selected as a source) that was encoded with Dolby D or DTS Digital Surround, the following symptoms may occur;
•No sound comes out at the beginning of playback.
•Noise comes out while searching for or skipping chapters or tracks.
A/PCM (Auto/PCM):
Normally select this. The system automatically detects the incoming signals.
DD:Select this if the symptoms above occur when playing a disc (or software) encoded with Dolby D.
DTS: | Select this if the symptoms above occur when |
| playing a disc (or software) encoded with DTS |
| Digital Surround. |
3 Press Cursor 3/2 to make an adjustment or selection.
Example:
D E C. D D
The adjustment is set and the display automatically disappears a few seconds later.
NOTE
•When “DD” or “DTS” is selected, if a signal encoded with another digital format comes in, you cannot listen to the sound. (The GDIGITAL or C indicator flashes.)
37