Advanced operations
See page 24 for button locations.
Sound and other settings
IMPORTANT
Before using the remote control for the following operation;
• Set the remote control mode selector to
AUDIO.
NOTE
Before you start operation;
•There is a time limit when doing the following steps. If the setting is cancelled before you finish, start from step 1 again.
1 Press SETTING.
Example:
D E C. A / P C M
2 Press Cursor Y/5 to select the item you want to set.
•DEC (Decode):
When you play an external source (DBS is selected as a source) that was encoded with Dolby D or DTS Digital Surround, the following symptoms may occur;
•No sound comes out at the beginning of playback.
•Noise comes out while searching for or skipping chapters or tracks.
A/PCM (Auto/PCM):
Normally select this. The system automatically detects the incoming signals.
DD:Select this if the symptoms above occur when playing a disc (or software) encoded with Dolby D.
DTS: | Select this if the symptoms above occur when |
| playing a disc (or software) encoded with DTS |
| Digital Surround. |
VIDEO: To watch DVD playback via the VIDEO jack.
S:To watch DVD playback via the
To watch DVD playback via the COMPONENT VIDEO OUT jacks.
•MON (Monitor Out):
Select the video output jack type by which you watch DVD playback after connecting your TV. (A pg. 11)
Set the video output to use AV COMPU LINK remote control system. (A pg. 41)
VIDEO: To watch DVD playback via the VIDEO jack.
S:To watch DVD playback via the
To watch DVD playback via the COMPONENT VIDEO OUT jacks.
3 Press Cursor 3/2 to make an adjustment or selection.
Example:
D E C. D D
The adjustment is set and the display automatically disappears a few seconds later.
NOTE
•When “DD” or “DTS” is selected, if a signal encoded with another digital format comes in, you cannot listen to the sound. (The GDIGITAL or C indicator flashes.)
35