Troubleshooting
•If you are having a problem with your System, check this list for a possible solution before calling for service.
•If you cannot solve the problem from the hints given here, or the System has been physically damaged, call a qualified person, such as your dealer, for service.
Symptom
No sound is heard.
Poor radio reception
The disc tray does not open.
The CD skips.
The CD does not play.
The MP3 disc does not play.
The readout time of the MP3 disc is too long.
The cassette holder cannot be opened.
Unable to record.
Unable to operate the Remote Control.
Operations are disabled.
Possible Cause
•Connections are incorrect, or loose.
•Headphones are connected.
•The antenna is disconnected.
•The AM (MW) Loop Antenna is too close to the System.
•The FM Wire Antenna is not properly extended and positioned.
•The AC power cord is not plugged in.
•Tray is locked.
The CD is dirty or scratched.
The CD is upside down.
•No MP3 files are recorded on the disc.
•MP3 files do not have the file extension
•MP3 files are not recorded in the format compliant with ISO 9660 Level 1 or Level 2.
The readout time varies with the complexity of the recording configuration.
During tape playing, the power cord was unplugged.
Cassette record protect tabs are removed.
•The path between the Remote Control and the sensor on the Unit is blocked.
•The batteries have lost their charge.
The
Action
•Check all connections and make correc- tions. (See pages 4 to 6.)
•Disconnect the headphones.
•Reconnect the antenna securely.
•Change the position and direction of the AM (MW) Loop Antenna.
•Extend FM Wire Antenna to the best reception position.
•Plug the AC power cord.
•Unlock the tray. (See page 15.)
Clean or replace the CD. (See page 25.)
Put the CD in with the label side up.
Replace the disc.
Do not use too many hierarchies and folders when recording. Also, do not record any other types of audio tracks together with MP3 files. (See page 11.)
Plug in the power cord, and turn on the Sys- tem.
Cover holes on back edge of cassette with tape.
•Remove the obstruction.
•Replace the batteries.
Unplug the System then plug it back in.
Specification
Amplifier |
| Tuner |
|
Output Power | 30 W per channel, min. RMS, driven | FM Tuner |
|
| into 6 Ω at 1kHz, with no more than | Tuning Range | 87.50 MHz - 108.00 MHz |
| 10% total harmonic distortion | AM Tuner |
|
| 28 W per channel, min. RMS, driven | Tuning Range | (MW) 522 kHz - 1 629 kHz |
| into 6 Ω at 1kHz, with no more than | Unit |
|
| 0.9 % total harmonic distortion (DIN) | Dimensions | 276 mm × 315 mm × 456 mm (W/H/D) |
Input Sensitivity/Impedance (1 kHz) | Mass | Approx. 8 kg | |
AUX IN | 500 mV/51 kΩ | Accessories |
|
Speaker terminals | 6 - 16 Ω |
| AM (MW) Loop Antenna (1) |
Phones | 32 Ω - 1 kΩ |
| Remote Control (1) |
Cassette Deck Section | 20 mW/ch output into 32 Ω | Power Specifications | Batteries R03 |
|
| ||
Frequency Response |
| Power Requirements | AC 230 V , 50 Hz |
Type I (NORMAL) | 63 Hz - 12 500 Hz | Power Consumption | 83 W (power on mode) |
Wow And Flutter | 0.15 % (WRMS) |
| 13 W (in Standby mode) |
CD Player |
|
| Approx. 2 W (in ECO mode) |
CD Capacity | 3 CDs |
|
|
Dynamic Range | 85 dB | Design and specifications are subject to change without notice. | |
85 dB |
|
| |
Wow And Flutter | Unmeasurable |
|
|
26