Operating instructions
3.Release the q (SOAKING) button whilst +Á (RINSE+) is continu-
ously illuminated.
Once +Á (RINSE+) has ceased to be illuminated, the additional rinse function is disabled.
| Water Cooling |
3 | The water is cooled prior to pumping out at the end of the main wash- |
| ing cycle (by adding cold water). (This setting is only effective for |
t (COTTONS/LINEN) at a temperature of over 40 °C.)
As supplied from the factory, the water cooling function is not enabled.
Enabling the water cooling function:
0 1. Turn the program selector to F (SHORT SPIN).
2.Press the k (PRE WASH) button for at least 5 seconds.
After the button has been kept pressed for 5 seconds, l (MAINWASH) flashes on the program progress indicator for 5 seconds.
3.Release the k (PRE WASH) button while l (MAINWASH) is flashing. Once the indicator has stopped flashing, the water cooling function is enabled. It continues to be enables until specifically disabled.
4.If you wish to check whether the water cooling function is enabled:
–Turn the program selector to F (SHORT SPIN).
–Press the k (PRE WASH) button briefly.
If the l (MAINWASH) indicator on the program progress display flashes, the water cooling function is enabled.
Disabling the water cooling function:
0 1. Turn the program selector to F (SHORT SPIN).
2.Press the k (PRE WASH) button for at least 5 seconds.
As soon as the button is pressed, l (MAINWASH) flashes on the pro- gram progress display. After 5 seconds l (MAINWASH) ceases to flash and illuminates continuously for 5 seconds.
3.Release the k (PRE WASH) button while l (MAINWASH) is continu- ously illuminated.
Once l (MAINWASH) has ceased to be illuminated, the water cooling function is disabled.
Additional Rinse and Water Cooling
The additional rinse and water cooling functions can be combined. Enable as under “Additional Rinse” and “Water Cooling”.
36