AEG 72620 manual Prepare the installation place, Installation on a concrete base

Page 41

Installation and Connection Instructions

Prepare the installation place

•The installation surface must be clean and dry, free of floor wax and other smearing substances, so that the appliance does not slip off. Do not use any lubricant as sliding aid.

•Installation on a high-veil carpet or floor tiles with soft sponge backs is not recommended because the standing safety of the appliance is then no longer ensured.

•By installation surfaces with small-format tiles, lay a conventional rubber mat underneath.

•Small unevenness of the floor surface should never be levelled out by laying pieces of wood, carton or similar elements, but rather basically compensated by adjusting the screw feet.

•When it is unavoidable to install the appliance besides a gas or a coal-fuelled cooker, due to spatial reasons: insert a piece of heat- insulating board (85 x 57 cm) between the cooker and the washing machine; the board side facing the cooker must be provided with an aluminium foil.

•The washing machine may not be installed in a frost-endangered room. Frost-caused damages!

•Flexible feed and drain tubings may not be crinkled or squeezed.

Installation on a concrete base

When installing on a concrete base, for safety reasons it is imperative that steel plates are installed, the washing machine is then installed in these plates. The steel plates are available from customer service under ET-No. 645 425 058.

Installation on vibrating floors

In the case of floors that vibrate, especially wooden floors with floor- boards that flex, a water-proof wooden panel of at least 15 mm thick- ness must be firmly screwed to at least 2 floor beams. If possible, install the appliance in a corner of the room: the wooden floor is more firmly supported in the corners and thus has less tendency to resonant vibra- tion.

41

Image 41

Contents ÖKO-LAVAMAT 72620 update Please read these user instructions carefully Dear customerContents Installation and Connection Instructions Service Departments/Guarantee Conditions Intended use SafetyPrior to initial start-up General safety Safety of childrenDispose of your old appliance DisposalDispose of the packaging Environmental protection tips Drawer for detergent and conditioner Description of the ApplianceFront View COTTONS/LINEN Control PanelProgram Selector WOOLLENS/HAND Washing Additional Program ButtonsPRE Wash SoakingConsumption Data and Time Required What does update mean?Stain Load in kg Water Energy TimeSort washing and prepare Before washing the first timePrepare washing cycle Washing types and care symbols Detergent and conditioner Which detergent and conditioner? Using Water SoftenerHow much detergent and conditioner? Information on Water HardnessAt the end of the washing program Performing a Washing CycleBrief Instructions Changing Spin Speed/Selecting Rinse Hold Setting the Washing ProgramLoading the Washing Setting the Delay TimerOpening and Closing the Door Add detergent/conditioner When using liquid detergentsStarting the Washing Program If the delay timer has been setProgram Progress Display Washing Program SequenceMulti-Display Changing the Spin SpeedWashing Cycle Complete/Removing the Washing Washing Program TablesSeparate Rinsing Separate Gentle Rinsing/Starching/ConditioningSeparate Spinning Type of WashingDetergent drawer Cleaning and CaringFill-in door Washing drumMalfunction Possible Cause Remedy Trouble ShootingWhat to do when… Rectly adjusted Instructions Service who have a retrofit If there are still gray stains on the washing If the washing results are not satisfactoryIf at the end of the last rinse foam is still visible If there are white remnants on the washingPerform emergency drain When the water is completely drained Clean the circulating pumpEmergency release for fill-in door Additional Rinse Rinse + Additional Rinse and/or Water CoolingEnabling the additional rinse function Disabling the additional rinse functionAdditional Rinse and Water Cooling Water CoolingEnabling the water cooling function Disabling the water cooling functionInstallation Safety Precautions Installation and Connection InstructionsRear View Front and Side ViewsBeneath countertops Installation of the applianceTransporting the appliance Remove transportation protection Installation on vibrating floors Prepare the installation placeInstallation on a concrete base Levelling on uneven floors Permissible water pressure Power supplyWater connection Water feed Delivery heights above 1m Water drain-offWater drain-off inside a siphon Water drain-off inside a basinTechnical data Autres agences étrangères assurant le service après-vente Further after-sales service agencies overseasWeitere Kundendienststellen im Ausland Otros puntos de Postventa en el extranjeroCroatia New Zealand Australia Korea South NamibiaBulgaria Kuwait/Arabian Gulf Cyprus Lebanon OmanJapan Singapore Slovenia Israel Malaysia Saudi ArabiaThailand Slovakia Rep South Africa HungaryIndex You will be charged even during the warranty period Service