Turn off the tap, then re | AEG 88730 specs

		Operating Instructions

Problem	Possible Cause	Remedy
The drain pump for the		Turn off the tap, then re-
washing machine runs		Turn off the tap, then re-
washing machine runs	The Aqua Control anti-flood	move the plug from the
constantly - even when	The Aqua Control anti-flood	move the plug from the
the appliance is	system has been activated.	mains and inform Customer
the appliance is		Service.
switched off.		Service.
switched off.
Fabric softener was not	The conditioner insert in the	Clean the detergent dis-
rinsed in, compart-	compartment for the condi-	Clean the detergent dis-
rinsed in, compart-	compartment for the condi-	penser drawer and attach the
ment æ for condition-	tioner is not correctly at-	penser drawer and attach the
ment æ for condition-	tioner is not correctly at-	conditioner insert securely.
ers is filled with water.	tached or is blocked.	conditioner insert securely.
ers is filled with water.	tached or is blocked.
		Pay attention to the maxi-
Washing heavily	Probably too much washing	mum load quantity (see Pro-
Washing heavily	Probably too much washing	gramme tables). In the case
creased	put in the drum.	gramme tables). In the case
creased	put in the drum.	of easy-care fabrics, select
		of easy-care fabrics, select
		the EASY IRON programme.
	Drain hose is kinked.	Remove the kink.
		Contact your local Service
The washing is not suf-	Maximum pump head (dis-	Force Centre. For pumping
ficiently spun. Water is	charge height 1m from the	heights over 1m a conver-
left in the drum.	unit's floor) is exceeded.	sion kit is available as a spe-
left in the drum.		cial accessory.
Error code (2 appears.		cial accessory.
Error code (2 appears.
		Switch off the appliance and
	Drain pump blocked.	pull out the mains plug.
		Clean the drain pump.
	The door is locked for safety	Wait until the DOOR/LIGHT
	reasons (DOOR/LIGHT display	Wait until the DOOR/LIGHT
The door cannot be	is off).	display lights up green.
The door cannot be	is off).
opened when the ap-		Cancel programme protec-
pliance is switched on.	The programme protection	Cancel programme protec-
	The programme protection	tion (see the section "Pro-
	function is set.	tion (see the section "Pro-
	function is set.	gramme protection“).
		gramme protection“).
	Water tap not fully opened.	Open the water tap fully.
Remnants of detergent	The inlet hose filter in the	Close the water tap. Unscrew
are building up in the		Close the water tap. Unscrew
are building up in the		the inlet hose from the water
detergent drawer.	coupling of the inlet hose at	the inlet hose from the water
detergent drawer.	coupling of the inlet hose at	tap and the appliance and
	the tap is blocked.	tap and the appliance and
	the tap is blocked.	clean the filter.
		clean the filter.
The rinsing water is	The cause is probably a de-	No negative influence on the
The rinsing water is	tergent with a high silicate	rinsing results, use a liquid
cloudy.	tergent with a high silicate	rinsing results, use a liquid
cloudy.	content.	detergent if necessary.
	content.	detergent if necessary.

Problem

Turn off the tap, then re-