AEG 74740 manual Rinse+ Spülen+

		Instructions for use
Problem	Possible Cause	Remedy
	Water valve is closed.	Open the water valve.
No water runs in.		Close the water valve. Un-
		screw the hose from the wa-
Fault code E10 ap-	Filter in screw connection of
		ter valve, remove the filter
pears. The indicator	the intake hose is blocked.
		and clean it under running
RINSE+ (SPÜLEN+,
		water.
RINCAGE+) flashes.
	Water tap is blocked with	Check water tap and have it
	limescale or is faulty.	repaired if necessary.
		Remove transport safeguard
	The transport safeguard has	as indicated in the instruc-
	not been removed.	tions for installation and
		connection.
	The height-adjustable screw	Adjust in accordance with
		the installation and connec-
	feet are not correctly set.
		tion instructions.
The washing machine
	There is not much washing in
vibrates during opera-		This does not impair the op-
tion or it is on an une-	the drum (e.g. only one
		eration of the machine.
ven surface.	dressing gown).
	The water could not be com-	Check the laying of the
		drainage hose and eliminate
	pletely pumped off before	the bend if necessary, or
	spinning because the drain-
		clean the solution pump and,
	age hose is bent
		if required, remove foreign
	or
		bodies from the pump hous-
	the solution pump is blocked.
		ing.
The washing solution	Too much detergent was	Meter the detergent exactly
of the main wash		in accordance with the
	probably used.
froths up a lot.		manufacturer's information.

35