AEG 82730 manual Tighten the intake hose

Page 34

Instructions for use

	Problem	Possible Cause	Remedy
		The screw connection on the	Tighten the intake hose
		intake hose is leaky.	screw connection
		The drainage hose is leaky.	Check the drainage hose and
		The drainage hose is leaky.	replace it if necessary.
			replace it if necessary.
		The washing solution pump	Close cover correctly.
		cover is not correctly closed.	Close cover correctly.
		cover is not correctly closed.
	Water runs out under	Washing stuck in the filling	Abort the program, remove
	the washing machine.	Washing stuck in the filling	washing from the door and
	the washing machine.	door.	washing from the door and
		door.	start a new program.
			start a new program.
			Shut the emergency drain
		The emergency drain hose is	hose off properly (see section
		The emergency drain hose is	"Performing an Emergency
		not properly shut off or it is	"Performing an Emergency
		not properly shut off or it is	Drain"). Call your after-sales
		not water-tight.	Drain"). Call your after-sales
		not water-tight.	service if the emergency
			service if the emergency
			drain hose is not water-tight.
	The drain pump for the
	The drain pump for the		Turn off the tap, then re-
	washing machine runs		Turn off the tap, then re-
	washing machine runs	The Aqua Control anti-flood	move the plug from the
	constantly - even when	The Aqua Control anti-flood	move the plug from the
	the appliance is	system has been activated.	mains and inform Customer
	the appliance is		Service.
	switched off.		Service.
	switched off.
	Conditioner not added,	Filter insert in the compart-	Clean the detergent drawer
	compartment æ for	ment for care agent not cor-	and firmly attach the filter
	care agent full of wa-	ment for care agent not cor-	and firmly attach the filter
	care agent full of wa-	rectly attached or is blocked.	insert.
	ter.	rectly attached or is blocked.	insert.
	ter.
			Pay attention to the maxi-
			mum filling quantity (see
	Washing heavily	Too mush washing probably	Program tables). For easy-
	creased	put in.	care textiles, select the pro-
			gram EASY IRON (STRIJKVRIJ,
			SANS REPASSAGE).

34

Image 34

Contents

ÖKO-LAVAMAT 82730 update Dear customer Contents Solution Cooling What to do ifPage Before Putting into Operation for the First Time SafetyCorrect Use Child Safety General SafetyDispose the packing material DisposalEnvironment Tips For polyoxymethylene, e.g. plastic clipsFront View Unit DescriptionDrawer for Washing Powder and Care Agent Control Panel Program SelectorWool WOL, LAINE/ P Handwash Program Silk ZIJDE, SOIE/ P Handwash ProgramAdditional Program Buttons Consumption Values and Time Requirements Water Protection Aqua Control + Aqua Alarm What Does Update Mean?Running Time Display Prepare the Washing Cycle Before the First WashSort and Prepare the Washing Washing Types and Care Codes How much washing detergent and care agent? Water SoftenerSet the Washing Program Run a Washing CycleBrief Instructions After the Washing Program EndsRevolutions Change Spin Speed / Select Rinse HoldIf necessary, change the spin speed for the final Per minuteOff Set the Delay TimerOpening and Closing the Filling Door Red The door is openAdd the Washing For information on the correct preparation of the washingCompartment for pre-wash agent/soaking agent If using Liquid Detergent/TabsAdd Washing Detergent/Care Agent Or for water softenerStart the Washing Program If the time preselection is setCompletion of the Washing Program Washing Cycle Ended/Remove WashingLights up, too much washing detergent was used Program Tables WashingDelicates Soaking Separate Conditioning/Starching/Impregnating Separate SpinCleaning and Care Washing Detergent Drawer Washing Drum Filling DoorCleaning the drain pump Before cleaning the drain pumpAfter remedying the fault, press the button Remedying FaultsWhat to do if Ter valve, remove the filter Fault code 1 ap Tighten the intake hose Head 1m from units floor If there are still grey stains on the washing If the washing result is not satisfactoryIf the washing is grey and limescale forms in the drum If foam is still visible after the final rinseCarry Out an Emergency Emptying Operation Aid of the emergency unlocking facility When all the washing solution has drained offEmergency Unlocking of the Filling Door Gency unlocking and remove the plug from the mainsTo rinse with more water No additional rinse is set when the unit is deliveredAdditional Rinse RINSE+ Set Additional RinseCancel Additional Rinse Solution CoolingSet the Solution Cooling Additional Rinse and Solution Cooling Cancel the Solution CoolingCanceling the Program Saving Function Setting the Program Saving FunctionProgram Saving Feature Child Safety FeatureSetting the Child Safety Cancelling the Child Safety FeatureSetting up and connection instructions Safety Instructions for InstallationWhen transporting the unit with a sack trolley Setting Up the UnitRemove the Transport Safeguard Transporting the UnitFirmly pull both hose holders off the unit Close off the hole with the plug cap GSetting Up on a Concrete Pedestal Prepare the Installation LocationSetting Up on a Vibrating floor Compensate for Floor Unevenness Water Connection Electrical ConnectionPermissible Water Pressure Water Inflow Water Drainage into a Siphon Water DrainageDraining the water into a basin Delivery Heads over 1m Technical DataDimensions Measurements in mmCustomer services BelgiumIndex Service When do you incur costs even during the warranty period?AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG