AEG 70730 manual Compensate for Floor Unevenness

Page 47

Setting up and connection instructions

Compensate for Floor Unevenness

Floor unevenness can be compensated for and the height can be cor- rected with the four adjustable screw feet. The height can be adjusted in a range of +10 ... -5 mm.

To adjust the feet use the special spanner supplied for removing the transport braces.

01. Slide the special key firmly onto the hexagon head of the

threaded foot as far as it will go.

2. Adjust the screw feet so that the unit is horizontal and stable. The unit must not wobble over when loaded.

3. If necessary, check the setting with a spirit level.

Attention! Never compensate for minor floor unevenness with underlays made of wood, card etc. Always adjust the adjustable feet.

47

Image 47

Contents ÖKO-LAVAMAT 70730 update Tel /3630444 Dear customerContents What to do if Remedying FaultsContents Correct Use SafetyBefore Putting into Operation for the First Time General Safety Child SafetyDispose the old appliance DisposalEnvironment Tips Dispose the packing materialDrawer for Washing Powder and Care Agent Unit DescriptionFront View Program Selector Control PanelWoollens WOL, LAINE/P Handwash EASY-CARES KREUKHERSTELLEND, DefroissablePRE Wash VOORWAS, Prelav Additional Program ButtonsConsumption Values and Time Requirements Water Protection Aqua Control What Does Update Mean?Sort and Prepare the Washing Before the First WashPrepare the Washing Cycle Washing Types and Care Codes Water Hardness Details How much washing detergent and care agent?Water Softener After the Washing Program Ends Run a Washing CycleBrief Instructions Set the Washing Program Change Spin Speed / Select Rinse Hold Set the Delay Timer/Soaking DurationThis run time is comprised as follows Soaking DurationAdd the Washing Opening and Closing the Filling DoorOr for water softener If using Liquid Detergent/TabsAdd Washing Detergent/Care Agent Compartment for pre-wash agent/soaking agentIf the time preselection is set Start the Washing ProgramMulti-Display Completion of the Washing ProgramChanging a Washing Program Program Sequence DisplayChange the Spin Speed Select the Additional ProgramWashing Cycle Ended/Remove Washing Washing Program TablesEASY-CARES PRE Wash Separate Spin Separate Conditioning/Starching/ImpregnatingSeparate Rinse Washing Detergent Drawer Cleaning and CareFilling Door Washing DrumWhat to do if Remedying FaultsRINCAGE+ flashes Water Sans Repassage Washing detergent If foam is still visible after the final rinse If the washing result is not satisfactoryIf the washing is grey and limescale forms in the drum If there are still grey stains on the washingCarry Out an Emergency Emptying Operation When all the washing solution has drained off Clean the Solution PumpEmergency Unlocking of the Filling Door Set Additional Rinse Cancel Additional RinseAdditional Rinse RINSE+/SPOELEN+/RINCAGE+ Cancelling the Child Safety Feature Child Safety FeatureSetting the Child Safety Feature Safety Instructions for Installation Setting UP and Connection InstructionsTransporting the Unit Setting Up the UnitRemove the Transport Safeguard When transporting the unit with a sack trolleyFirmly pull both hose holders off the unit Setting Up on a Vibrating floor Prepare the Installation LocationSetting Up on a Concrete Pedestal Compensate for Floor Unevenness Permissible Water Pressure Electrical ConnectionWater Connection Water Inflow Draining the water into a basin Water DrainageWater Drainage into a Siphon Delivery Heads over 1m Technical DataDimensions Page Page Index When do you incur costs even during the warranty period? Service