AEG 54840 manual Water inlet filter, Emergency emptying out

Page 28

28Care and cleaning

Water inlet filter

If you notice that the machine is taking longer to fill, check that the filter in the water inlet hose is not blocked.

1.Turn off the water tap.

2. Unscrew the hose from the tap.

3. Clean the filter in the hose with a stiff brush.

4. Screw the hose back onto the tap.

Emergency emptying out

If the water is not discharged, proceed as follows to empty out the machine:

1.pull out the plug from the power socket;

2.close the water tap;

3.if necessary, wait until the water has cooled down;

4.open the pump door;

5.place a bowl on the floor and place the end of the emergency emptying hose into the bowl. Remove its cap. The water should drain by gravity into the bowl. When the bowl is full, put the cap back on the hose. Empty the bowl. Repeat the procedure until water stops flowing out;

6.clean the pump if necessary as previously described;

7.replace the emergency emptying hose in its seat after having plugged it;

8.screw the pump again and close the door.

Page 27 Page 29
Image 28
Page 27 Page 29
Contents
Lavamat Dear Customer Contents Preparing the wash cycle 20-23 Installation 36-39 Packaging materials Old machine Ecological hintsPrior to using for the first time Safety informationGeneral safety Installation Use Child SafetyKeep all detergents in a safe place out of children’s reach Product description Detergent dispenser drawerControl panel «Start/Pause» button «Delay start» buttonFirst Use Daily Use Load the laundryMeasure out the detergent and the fabric softener Pull out the dispenser drawer until itSelect the required programme Select the spin speed or the Rinse Hold optionSynthetics Synth Wool Handwash SilkSelect the Stain option Programme option buttonsTo empty the water out Select the Extra Quick option Select the Delay StartSelect the «Start/Pause» Delay Start can not be selected with Drain programme Programme progress displaySelect an additional rinse Altering an option or a running programmeCancelling a programme Interrupting a programmeOpening the door after the programme has started At the end of the programmeWashing programmes Spin reduction Rinse HoldExtra rinse Spin reduction Rinse Hold Extra rinse Spin reductionPompen Vidange Programme informations Opfrissen RafraichirTemperatures Preparing the wash cycleSorting out the laundry Before loading the laundryFollowing weights are indicative Laundry weightsRemoving stains Detergents and additives Marked before starting the wash programmeQuantity of detergent to be used Degrees of water hardnessInternational wash code symbols Energetic wash Delicate washCare and cleaning Door seal Washing drumDrain pump Care and cleaning Water inlet filter Emergency emptying outFrost precautions Possible cause/Solution Something not workingMachine fills then empties immediately Possible cause/Solution Something not working Techinical Data Door includedConsumption value Rinses Drain Spin Refresh EcoInstallation UnpackingUnscrew the three bolts with the supplied SpannerFitted on the door seal Positioning and levellingContaining the instruction booklet Water inlet Water drainageThis appliance must be connected to a cold water supply TConnect the water inlet hose supplied withPermanent connection Electrical connectionConnect the machine to an earthed socket Enviroment concerns Packaging materialsOld machine Ecological hintsDeclaration of Guarantee Terms BelgiumAddress for our consumer services department Belgium Electrolux Home Products Consumer servicesEuropean Guarantee LuxembourgSubject to change without notice 132 970 011 01