AEG 54840 Positioning and levelling, Fitted on the door seal, Containing the instruction booklet

Page 37

 

 

Installation

37

5.

Open the porthole and remove the polystyrene block

 

 

 

fitted on the door seal.

 

 

6.

Fill the smaller upper hole and the two large ones with

HEC0010

 

 

the corresponding plastic plug caps supplied in the bag

 

 

 

containing the instruction booklet.

 

 

Positioning and levelling

Install the machine on a flat hard floor.

Make sure that air circulation around the machine is not impeded by carpets, rugs etc.

Before placing it on small tiles, apply a rubber coating.

Never try to correct any unevenness in the floor by putting pieces of wood, cardboard or similar materials under the machine.

If it is impossible to avoid positioning the machine next to a gas cooker or coal- burning stove, an insulating panel covered with

aluminium foil on the side facing the cooker or stove, must be inserted between the two appliances.

The machine must not be installed in rooms where the temperature can drop below 0.

The water inlet hose and the drain hose must not be kinked.

Please ensure that when the appliance is installed, it HEC007 is easily accessible for the engineer in the event of a breakdown.

Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.

Image 37
Contents Lavamat Dear Customer Contents Preparing the wash cycle 20-23 Packaging materials Old machine Ecological hints Installation 36-39Prior to using for the first time Safety informationGeneral safety Installation Use Child SafetyKeep all detergents in a safe place out of children’s reach Detergent dispenser drawer Product descriptionControl panel «Start/Pause» button «Delay start» buttonFirst Use Load the laundry Daily UseMeasure out the detergent and the fabric softener Pull out the dispenser drawer until itSelect the spin speed or the Rinse Hold option Select the required programmeSynthetics Synth Wool Handwash SilkSelect the Stain option Programme option buttonsTo empty the water out Select the Extra Quick option Select the Delay StartSelect the «Start/Pause» Programme progress display Delay Start can not be selected with Drain programmeSelect an additional rinse Altering an option or a running programmeInterrupting a programme Cancelling a programmeOpening the door after the programme has started At the end of the programmeSpin reduction Rinse Hold Washing programmesExtra rinse Spin reduction Rinse Hold Extra rinse Spin reductionPompen Vidange Opfrissen Rafraichir Programme informationsPreparing the wash cycle TemperaturesSorting out the laundry Before loading the laundryFollowing weights are indicative Laundry weightsRemoving stains Marked before starting the wash programme Detergents and additivesDegrees of water hardness Quantity of detergent to be usedEnergetic wash Delicate wash International wash code symbolsCare and cleaning Door seal Washing drumDrain pump Care and cleaning Emergency emptying out Water inlet filterFrost precautions Something not working Possible cause/SolutionMachine fills then empties immediately Possible cause/Solution Something not working Door included Techinical DataRinses Drain Spin Refresh Eco Consumption valueUnpacking InstallationUnscrew the three bolts with the supplied SpannerFitted on the door seal Positioning and levellingContaining the instruction booklet Water drainage Water inletThis appliance must be connected to a cold water supply TConnect the water inlet hose supplied withPermanent connection Electrical connectionConnect the machine to an earthed socket Packaging materials Enviroment concernsOld machine Ecological hintsBelgium Declaration of Guarantee TermsBelgium Electrolux Home Products Consumer services Address for our consumer services departmentLuxembourg European GuaranteeSubject to change without notice 132 970 011 01