AEG 54840 Electrical connection, Permanent connection, Connect the machine to an earthed socket

Page 39

Installation 39

i.e. the inside diameter of the drain pipe must be larger than the outside diameter of the drain hose.

The drain hose must not be kinked.

P1118

Important!

The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Centre.

Electrical connection

This machine is designed to operate on a 220-230 V, single-phase, 50 Hz supply.

Check that your domestic electrical installation can take the maximum load required (2.2 kW), also taking into account any other appliances in use.

Connect the machine to an earthed socket.

The manufacturer does not accept any responsibility for damage or injury through failure to comply with the above safety precaution.

Should the power supply cable need to be replaced, this MUST be carried out by a Service Centre.

Permanent connection

In the case of a permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3 mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point. This operation must be performed by a qualified electrician.

The power supply cable must be easily accessible after installing the machine.

Image 39

Contents Lavamat Dear Customer Contents Preparing the wash cycle 20-23 Packaging materials Old machine Ecological hints Installation 36-39Safety information Prior to using for the first timeGeneral safety Installation Child Safety UseKeep all detergents in a safe place out of children’s reach Detergent dispenser drawer Product description«Start/Pause» button «Delay start» button Control panelFirst Use Pull out the dispenser drawer until it Daily UseLoad the laundry Measure out the detergent and the fabric softenerWool Handwash Silk Select the required programmeSelect the spin speed or the Rinse Hold option Synthetics SynthProgramme option buttons Select the Stain optionTo empty the water out Select the Delay Start Select the Extra Quick optionSelect the «Start/Pause» Altering an option or a running programme Delay Start can not be selected with Drain programmeProgramme progress display Select an additional rinseAt the end of the programme Cancelling a programmeInterrupting a programme Opening the door after the programme has startedExtra rinse Spin reduction Washing programmesSpin reduction Rinse Hold Extra rinse Spin reduction Rinse HoldPompen Vidange Opfrissen Rafraichir Programme informationsBefore loading the laundry TemperaturesPreparing the wash cycle Sorting out the laundryLaundry weights Following weights are indicativeRemoving stains Marked before starting the wash programme Detergents and additivesDegrees of water hardness Quantity of detergent to be usedEnergetic wash Delicate wash International wash code symbolsCare and cleaning Washing drum Door sealDrain pump Care and cleaning Emergency emptying out Water inlet filterFrost precautions Something not working Possible cause/SolutionMachine fills then empties immediately Possible cause/Solution Something not working Door included Techinical DataRinses Drain Spin Refresh Eco Consumption valueSpanner InstallationUnpacking Unscrew the three bolts with the suppliedPositioning and levelling Fitted on the door sealContaining the instruction booklet TConnect the water inlet hose supplied with Water inletWater drainage This appliance must be connected to a cold water supplyElectrical connection Permanent connectionConnect the machine to an earthed socket Ecological hints Enviroment concernsPackaging materials Old machineBelgium Declaration of Guarantee TermsBelgium Electrolux Home Products Consumer services Address for our consumer services departmentLuxembourg European GuaranteeSubject to change without notice 132 970 011 01