Something not working 31
Problem
The machine fills then empties immediately:
The machine does not empty and/or does not spin:
There is water on the floor:
Possible cause/Solution
The end of the drain hose is too low.
•Refer to relevant paragraph in «water drainage» section.
The drain hose is squashed or kinked. (Yellow
Start/Pause pilot light flashes)
• Check the drain hose connection.
The drain pump is clogged. (Yellow Start/Pause pilot light flashes)
• Clean the drain pump.
The option 
has been selected.
• Select the Drain or Spin programme.
The laundry is not evenly distributed in the drum.
• Redistribute the laundry.
Too much detergent or unsuitable detergent (creates too much foam) has been used.
• Reduce the detergent quantity or use another one.
Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp.
• Check the water inlet hose connection.
The drain hose is damaged.
• Change it with a new one.
The cap on the emergency emptying hose has not been replaced after cleaning the pump.
•Put the cap back on the emergency emptying and place the latter back in its seat.