Blomberg WM 67121 NBL00 installation instructions Descaling the washer

Page 28

below:

Pull out the emergency drain hose from its housing.

Place a large container at the end of the hose. Drain the water off into the container by pulling out the plug at the end of the hose. If the amount of water to be drained off is greater than the volume of the container, replace the plug, pour the water out, then resume the draining process.

After draining process is completed, replace the plug into the end of the hose and fit the hose back into its place.

When there is no water left, turn the pump filter until it is completely loose and remove it.

Clean any residues inside the filter as well as fibers, if any, around the impeller region.

Never force the filter while replacing it into its housing. Fit the filter fully into its housing; otherwise, water may leak from the filter cap.

4- Close the filter cap.

Close the two-piece filter cap of your product by pushing the tab on it. Close the one-piece filter cap of your product by fitting the tabs on the bottom into their positions and pushing the upper part of it.

Descaling the washer

Hard water can cause scale build- up inside the drum and other parts of your washer in time. Scaling may lead to some serious problems such as clogging in hoses, heater or pump failure eventually.

To prevent scaling, wash drum should be cleaned frequently. Do not use abrasive materials such as metal wool while cleaning the drum.

Take the manufacturer’s instructions into account if you are using a descaling agent. Descaling agents may contain materials that are hazardous for washer components. Use descaling agents compatible for use in clothes washers.

When using a powder descaling agent, add 1 cup to the main wash compartment of the dispenser and run a regular hot cycle (with extra rinse) without any clothes and detergents.

28

EN

Image 28
Contents Front-Loading Automatic Washer WM 67121 NBL00 Please read this guide first Explanation of symbolsThis guide will… Table of Contents Your Washer OverviewSpecifications Important Safety Instructions Page Page Right Location Installation Installation InstructionsInstallation Clearances Allowable Clearances for Undercounter Installation Allowable Clearances for Closet InstallationStacked Installation Removing packaging reinforcementElectrical Connection Levelling the washerGrounding Instructions Power supply and circuit Water Supply ConnectionInstallation Checklist DrainageTransportation Disposal InformationAppliance Disposal Packing DisposalOperating Instructions First UseLaundry Tips Before the first usePreparing the laundry Loading the washerDetergent Quantity Detergent UseDetergent Dispenser Water Consumption Liquid Chlorine Bleach CompartmentSelecting a program and operating your washer Control panelTurning the washer on Program cycle selectionProgram Cycle Selection Table Wash Cycles Special programsAuxiliary functions Options Time displayChanging the delay time Canceling the time delayStarting the Program Progress of programEnding the program through canceling Adding/removing laundry in standby modeChild-proof lock Door lockQuick instructions for daily use User maintenance instructions Cleaning detergent dispenserCleaning the door seal Cleaning the outer cabinet and control panelCleaning the water inlet strainers Cleaning the drain pump filterDescaling the washer Troubleshooting When a process is Washer will wait until there is a Automatic spin correction Laundry in the drum. No spinning Do not load the washer in excess Insufficient amount of detergent can Laundry in the machine. The laundry Be clogged Warranty Statement for the Blomberg Clothes Washers HOW to GET Service