Blomberg WM 67121 NBL00 installation instructions Laundry in the drum. No spinning

Page 33

 

 

The automatic spin correction

 

 

system might have been activated

 

 

due to the unbalanced distribution of

 

 

the laundry in the drum. No spinning

 

There may be an imbalance of

is performed when the laundry is

 

load in the drum. Therefore, the

not evenly distributed in the drum

 

program cycle might have been

to prevent any damage to the

 

completed without spinning.

appliance and to its environment.

 

 

 

 

 

The laundry in the drum may be

 

 

tangled up too much. Laundry

 

 

should be rearranged and re-spun.

Washer did not spin.

 

 

Unbalance detection due to 1-2

Add more laundry (e.g. a few

 

 

small items in the drum (uneven

additional towels) to the drum and

 

load distribution)

start a “Spin” or “Spin&Drain” cycle.

 

 

 

 

Drain hose may be folded.

Check the drain hose and straighten

 

if necessary.

 

 

 

 

 

 

“No spin” setting may be

See “Spin Speed Selection”.

 

adjusted.

 

 

 

 

 

 

 

Clean the drain pump filter (See

 

Drain pump filter or drain itself

“User maintenance instructions” ). If

 

may be clogged.

the house drain pipes are clogged,

 

 

call a plumber for assistance.

 

Using insufficient amount of

Use the recommended amount of

 

HE detergent appropriate for water

 

detergent.

 

hardness and soil level of laundry.

 

 

 

 

 

 

 

Select the proper temperature for

 

Washing at low temperatures for

the laundry to be washed (See

 

a long time

“Laundry Tips” & “Program Cycle

 

 

Selection”).

 

Using insufficient amount of

If the water hardness is high, using

 

an insufficient amount of detergent

 

detergent for hard water (soil can

 

can cause laundry to turn gray over

 

stick to the laundry)

 

time.

 

 

Washing performance

Using excessive amount of

 

is poor: Laundry turns

It is difficult to eliminate such

detergent (detergent can stick to

gray/yellow

grayness once it occurs.

the laundry).

 

 

 

 

 

 

Not using HE detergent

Use HE detergent.

 

 

 

 

Dyeing problem occurs.

Sort the wash load by color (See

 

“Laundry Tips”).

 

 

 

 

 

 

Hot water inlet temperature is not

Set your water heater for delivering

 

high enough.

120-140F (48-60 C) hot water.

 

 

 

 

A higher temperature might have

Select the proper program cycle and

 

temperature according to the type

 

been selected.

 

and soiling degree of the laundry.

 

 

 

 

 

33

EN

Image 33
Contents Front-Loading Automatic Washer WM 67121 NBL00 Explanation of symbols Please read this guide firstThis guide will… Table of Contents Overview Your WasherSpecifications Important Safety Instructions Page Page Installation Instructions Right Location InstallationInstallation Clearances Allowable Clearances for Closet Installation Allowable Clearances for Undercounter InstallationStacked Installation Removing packaging reinforcementLevelling the washer Electrical ConnectionGrounding Instructions Water Supply Connection Power supply and circuitDrainage Installation ChecklistDisposal Information TransportationAppliance Disposal Packing DisposalFirst Use Operating InstructionsLaundry Tips Before the first useLoading the washer Preparing the laundryDetergent Use Detergent QuantityDetergent Dispenser Liquid Chlorine Bleach Compartment Water ConsumptionControl panel Selecting a program and operating your washerTurning the washer on Program cycle selectionProgram Cycle Selection Table Special programs Wash CyclesTime display Auxiliary functions OptionsCanceling the time delay Changing the delay timeStarting the Program Progress of programAdding/removing laundry in standby mode Ending the program through cancelingChild-proof lock Door lockQuick instructions for daily use Cleaning detergent dispenser User maintenance instructionsCleaning the door seal Cleaning the outer cabinet and control panelCleaning the drain pump filter Cleaning the water inlet strainersDescaling the washer Troubleshooting When a process is Washer will wait until there is a Automatic spin correction Laundry in the drum. No spinning Do not load the washer in excess Insufficient amount of detergent can Laundry in the machine. The laundry Be clogged Warranty Statement for the Blomberg Clothes Washers HOW to GET Service