Blomberg WM 67121 NBL00 installation instructions Troubleshooting

Page 29

8Troubleshooting

 

 

 

Problem

Cause

Explanation / Suggestion

 

 

 

 

There may be some water in your

It is not harmful to your washer. You

Water in the washer.

appliance when you receive it.

should run a “sanitary” cycle without

This is from the quality control

any clothes and laundry additives

 

 

process and is normal.

before the first use of your washer.

 

 

 

 

Faucets may be turned off.

Open the water faucets fully.

 

 

 

 

Water inlet hose may be folded.

Check the water inlet hose and

 

straighten if necessary.

 

 

 

 

 

 

Water inlet strainers might be

Clean the water inlet strainers.

 

clogged.

 

 

 

 

 

 

 

Call an electrician and have the

 

Is there power at the outlet?

power outlet / circuit breaker / fuse

Washer does not fill with

 

checked.

water or wash after the

Washer might be unplugged.

Plug the power cord to a live

program was selected

electrical outlet.

and the “Start/Pause/

 

 

Cancel” button was

Drain hose may be folded.

Check the drain hose and straighten

pressed.

if necessary.

 

 

 

 

Washer may be in handwash,

Wait for a short time and tumbling

 

wools or soak cycle.

will start.

 

 

 

 

 

Clean the drain pump filter (See

 

Drain pump filter or drain itself

“User maintenance instructions” ). If

 

may be clogged.

the house drain pipes are clogged,

 

 

call a plumber for assistance.

 

Door may not be closed properly.

Close the loading door.

 

 

 

 

Drain hose may be folded.

Check the drain hose and straighten

 

if necessary.

Washer does not drain

 

 

 

water / Washer drains

 

Clean the drain pump filter (See

water slowly.

Drain pump filter or drain itself

“User maintenance instructions” ). If

 

may be clogged.

the house drain pipes are clogged,

 

 

call a plumber for assistance.

The water being taken in

Improper position of the drain

Connect the drain hose as described

in the user manual (See “Installation

is directly discharged.

hose.

Instructions, Drainage”).

 

 

 

 

 

No water can be seen

This is not a problem. The water

 

in the drum during

level is not visible from the

 

washing.

outside of the washer.

 

 

 

 

Washer stopped shortly

Washer can stop temporarily due

It will resume operating when the

after the program cycle

to low voltage.

voltage is back to the normal level.

started.

 

 

29

EN

Image 29
Contents Front-Loading Automatic Washer WM 67121 NBL00 This guide will… Explanation of symbolsPlease read this guide first Table of Contents Overview Your WasherSpecifications Important Safety Instructions Page Page Installation Clearances Installation InstructionsRight Location Installation Allowable Clearances for Closet Installation Allowable Clearances for Undercounter InstallationStacked Installation Removing packaging reinforcementGrounding Instructions Levelling the washerElectrical Connection Water Supply Connection Power supply and circuitDrainage Installation ChecklistDisposal Information TransportationAppliance Disposal Packing DisposalFirst Use Operating InstructionsLaundry Tips Before the first useLoading the washer Preparing the laundryDetergent Dispenser Detergent UseDetergent Quantity Liquid Chlorine Bleach Compartment Water ConsumptionControl panel Selecting a program and operating your washerTurning the washer on Program cycle selectionProgram Cycle Selection Table Special programs Wash CyclesTime display Auxiliary functions OptionsCanceling the time delay Changing the delay timeStarting the Program Progress of programAdding/removing laundry in standby mode Ending the program through cancelingChild-proof lock Door lockQuick instructions for daily use Cleaning detergent dispenser User maintenance instructionsCleaning the door seal Cleaning the outer cabinet and control panelCleaning the drain pump filter Cleaning the water inlet strainersDescaling the washer Troubleshooting When a process is Washer will wait until there is a Automatic spin correction Laundry in the drum. No spinning Do not load the washer in excess Insufficient amount of detergent can Laundry in the machine. The laundry Be clogged Warranty Statement for the Blomberg Clothes Washers HOW to GET Service