Installation
1.IMPORTANT TO ALLOW 6” CLEAR SPACE FOR ACCESS TO CONTROL BOX. Urn should be level, both front to back and left to right.
2.CONNECT WATER LINE. 3/8” NPT water inlet located at left end and provide shutoff valve and union in supply line near urn. 140OF. hot water must be used, 30PSI mini- mum - 70PSI maximum. We strongly recommend the use of copper or aluminum tub- ing to provide flexibility and avoid strain on the urn. 3/8” O.D. minimum tubing is rec- ommended.
Model No. | 87710 | ||
Actual Coffee Capacity Each Liner | 10 | Gal. | |
Water Compartment Capacity | 24 | Gal. | |
Brew Capacity, Gals. per Hour | 80 |
| |
Electric Supply Voltage | 240V/208V | ||
1 | Phase Heater Size | 15KW / 15KW | |
1 | Phase Amperes | 63 | / 72 |
3 | Phase Heater Size | 15KW / 15KW | |
3 | Phase Amperes | 36 | / 42 |
3.CONNECT URN TO ELECTRIC POWER. Check to be sure that the nameplate mark- ing of voltage, phase and the number of wires matches supply lines. Remove cover on control housing. The terminal block for the line connections is located in the housing on the left end. See drawing, as required. It is recommended that a fused disconnect switch be installed near urn. The urn body must be grounded either through metallic conduit or else by means of ground wire. An experienced electrician should be respon- sible for the installation of the urn, and its associated supply line. NOTE: Neutral wire required on all single phase and on 208 volt 3 phase power supplies to operate 120 volt AC control circuit.
On single phase, 2 wire service (no neutral) or 3 phase 3 wire service (no neutral) 120 volt AC power to operate control circuit must be supplied as circuit. Do not replace cover until completing installation
4.FILL WATER COMPARTMENT. Turn on water supply and electric service to urn. Water compartment should fill to
Turn thermostat knob to BREW position. Pilot light over knob should light showing heater power on. Water compartment should reach operating temperature approxi- mately 45 minutes later. When the pointer on thermometer approaches the “W” in the blue BREW zone, urn is ready for automatic operation.
|
|
American Metal Ware 87710E Coffee Urn | Page 5 |