c) Mounting the door
Fix the hinges (1) to the machine by means of the M5x15 screws
d) Counter-magnet (6)
The appliance is
Its position must correspond to the magnet (4) on the appliance (See fig. D).
Recommendations regarding the construction and fitting of a base when the installation requires an integrated appliance to be raised
Where the appliance has been raised by mounting onto a wooden base provided by the installer. The material used to construct the base should have a non slip surface, be water repellent and if possible be one solid piece.
If it is not possible to use one solid piece, due to the additional height required, ensure that any additional strips of timber are glued and screwed to the underside of the base (see Fig. F).
6 |
4 |
5 mm Hardwood strip
40 mm
100 mm
Additional pieces of timber should run from front to back
P0984 | D |
|
F
Front view
If the door has to be opened from left to right, invert the position of the plates (7), the magnet (4) and the plate (5) (Fig. B and E). Mount the countermagnet (6) and the hinges (1) as previously described.
|
|
| E |
4 |
|
| 6 |
|
|
| |
| 5 | 7 | 1 |
|
| ||
|
|
| |
|
| 3 |
|
P0983 |
|
| 2 |
|
|
|
Drill four fixing holes see Fig. G
| |
| 490 mm |
| 95 mm |
| Front edge |
| 50 mm |
G | Top view |
|
9