Fisher & Paykel IWL12 installation instructions Single beep every second

If Your Intuitive Beeps For Help

EN

“I am not getting any WATER”

The faucets have not been turned on.

Inlet hose screens may be blocked.

The hoses may be kinked.

The drain hose is too low or the drain hose is pushed into the standpipe too far and the water is siphoning out of the machine. (See Installation Instructions, pages 6 – 7).

The flow rate of the supply water is too slow.

“I am OVERLOADED”

The machine is overloaded and cannot agitate.

Ensure the machine is stationary.

Remove items until the remaining ones can move freely, or select a higher water level.

Check the machine is not syphoning.

“I have TOO MANY SUDS”

The machine has a suds build-up. (Too much detergent may have been used for the amount of soil in the load).

Wait for suds to dissolve (about 20 minutes).

Rinse clothes using a deep rinse.

“I can’t LOCK THE LID”

Make sure the lid is closed.

Press START PAUSE (Refer to page 18).

If the symptom persists refer to page 40 for service contacts.

Single beep every second and...

“I need service” message and fault number

1.Turn your machine off at the wall.

2.Wait 1 minute and turn it back on.

3.Check the machine is level.

4.Remove load and retry.

5.Put through a Deep Rinse and Spin.

6.If the fault re-occurs repeat Step 1.

If the problem persists refer to the service contacts on page 40.

(Before calling for help please locate the serial number of your washer on its back top left corner).

37