LG Electronics 3600 operation manual Packing Replacement Procedures

Page 22

Packing Replacement Procedures

3.	Push the two bolts (100-318) through the tube spacers	FIGURE 5

(331-074) & screw into the cover assembly (331-234). Using a 1/2” wrench, tighten the two bolts evenly (alternating between them) until you reach 20 ft-lbs.

4.Reassemble lower suction valve assembly by placing the suction seat (331-409) O-ring (106-011), suction ball (331-030) and suction ball guide (331-029) in the suction nut (331-034) & screw onto the fluid pump body.

5.Start the machine & operate slowly to check the piston rod for binding. Adjust the bolts, holding the fluid pump body to the cover assembly, if necessary. This will eliminate any binding.

76Tighten packing nut clockwise until resistance is felt against the Belleville Springs, then go 3/4 of a turn more. Put five drops of Airlessco Throat Seal Oil into the packing nut.

7.Run the machine at full pressure for several minutes. Release the pressure by following the Pressure Relief Procedure & readjust the packing nut per step 6 above.

8.Install the connecting rod safety shield

(Fig. 1 Part # 331-111) so that the small hole is in the upper right hand corner.

FIGURE 6

20

Image 22

Contents SERVICE/OPERATION Table of Contents Introduction IntroductionSafety Warnings Toxic Fluid HazardMedical Treatment Always ground all of these components Flushing Before Performing Adjustments or Repairs When Testing for SparkFlushing Daily Maintenance Airlessco Throat Seal Oil Ounce bottle Quart bottlePressure Relief Procedure USE Minimum PressureRemove the snap-on cover plate over the piston Grounding Setting Up to Stripe or SprayConnect the hose and gun Flush the sprayerPrepare the Material Adjusting the PressureStarting Up Starting the SprayerWhen Shutting off the Sprayer Avoiding Tip ClogsStriping Operation Refer to figure belowSpray GUN Spray TIP AssemblySpray Gun Operation Major Components of Spray GUN Reversible REV-TIPDefects Cause Spray Gun TroubleshootingTest the Pattern Correction Field Troubleshooting Problem Cause SolutionServicing the Fluid Pump Fluid Pump DisconnectServicing the Suction Assembly Servicing the Piston Rod Outlet ValvePacking Replacement Procedures Replacement InstructionsPacking Replacement Procedures Electrical Control Board Replacement Pressure Calibration on the Electrical Control BoardInstall NEW Clutch AS Follows Clutch ReplacementRemove Clutch AS Follows Troubleshooting Clutch Does Not Engage Gear Box Assembly Part No Part Number DescriptionSpray Gun Assembly Part No Gun Mount Assembly Part NoFrame Assembly Swivel Wheel Assembly Suction Assembly Part No Part Number Description QtyStriping TIP Striping Tip GuideOrifice Size Inches Accessoriesairlessco Quick F