I nstallation
Normal Tap without thread & screw type inlet hose
1. Unscrew the fixing screw to attach the tap.
2. Push the connector up till the rubber packing is in tight contact with the tap. Then tighten the 4 screws.
3. Push the water supply hose vertically upwards so that the rubber packing within in the hose can adhere completely to the tap and then tighten it by screwing it to the right.
Normal Tap without thread & one touch type inlet hose
1. Untighten the upper connector | 2. Push the upper connector up till | |
screw. |
| the rubber packing is in tight |
|
| contact with the tap. Then |
Upper | Rubber | tighten the 4 screws. |
Connector | packing |
|
Fixing screw | Middle | Rubber packing |
| ||
| connector |
|
|
| Upper |
• In case the diameter of the tap is | Connector | |
| ||
large remove the guide plate. | Middle | |
|
| connector |
3.Connect the water supply hose to the middle connector, pushing the plate down.
Upper
Connector
Plate
Water supply 
hose 
Guide plate
Connector
Used the horizontal tap
Horizontal tap
• Turn the middle connector not | • To separate the water supply | |
to have water leaked. | hose from the middle connector | |
• Make sure that the rubber seal | shut off the tap. Then pull the | |
inlet hose down, pushing the | ||
is inside the hose connector. | ||
plate down. | ||
| ||
Hose connector |
| |
Rubber seal |
|
Extension tap |
|
Square tap | • Make sure that there are no |
kinks in the hose and that it is | |
| not crushed. |
9