If the new dryer is installed into an existing exhaust system you must make sure:
•The exhaust system meets all local, state, and national codes.
•That a flexible plastic duct is not used.
•To Inspect and clean all lint buildup from inside the existing duct.
•The duct is not kinked or crushed.
•The exhaust hood damper opens and closes freely.
The static pressure in any exhaust system must not exceed 0.83 inches of water column, or be less than 0. This can be measured with the dryer running with a manometer at the point where the exhaust duct connects to the dryer. A
EXHAUST DIRECTIONS
All dryers shipped from the factory are set up for rear exhausting. However exhausting can be on the right, left or bottom of the dryer.
•Remove the access panel at back of dryer to gain access to the internal ducts.
•Disconnect the duct exhaust from the blower housing.
•Remove the desired knockout plate (either right or left side).
•Attach a 90° elbow duct to the blower housing and facing desired opening.
•Reinstall the rear access panel.
01 Installing your dryer
Same as other side
| Frontof dryer |
Blower Housing
Duct Exhaust
EXHAUST DUCT LOCATING DIMENSIONS
WARNING
SPECIAL ACCESSORY
Stacking kit (Model no:SK-2A)
You can obtain the stacking kit from your retailer. With this kit you can combine your Samsung dryer with a Samsung washing machine in a washing and drying column. The appliances are stacked in a
IMPORTANT TO INSTALLER
Please read the following instructions carefully before installing the dryer. These instructions should be kept for future reference.
REMOVE THE DOOR FROM ALL DISCARDED APPLIANCES TO AVOID THE DANGER OF A CHILD WARNING SUFFOCATING.
Installing your dryer _9