Parts provided with your washer | H Hot water connection |
Back side of the washing mashine | P Cold water connection |
|
| NOTICE: If any parts are missing please notify your | ||
|
| dealer immediately. |
| |
|
| Set up on a pedestal with drawer |
| |
| Pedestal item number: WMZ 20490 |
| ||
|
|
| ||
|
| Mount washer on the pedestal according to the |
| |
| instructions in the installation kit. |
| ||
|
|
|
| |
| Installation checklist |
| ||
| Review the following list and check off each step as it is | |||
|
| completed during installation. |
| |
|
| è | Installation Step | Page |
|
|
| If installing to a pedestal (base), com- | 12 |
|
|
| plete the base installation before |
|
| # |
| removing the transportation bolts |
|
|
| Completely remove all four shipping | 12 | |
|
|
| ||
|
|
| bolts keeping the bolt and bushing |
|
|
|
| assemblies intact |
|
|
|
| Connect the water supply hose and | 12 |
|
|
| drain hose |
|
|
|
| Connect the electrical power | 14 |
( Power cord with plug |
| Slide the washing machine into its final |
| |
| location |
| ||
0 Literature pack; contents: |
|
| ||
| Level the washing machine (as low as | 14 | ||
| User manual |
| ||
▯ |
| possible) |
| |
▯ | Warranty | Before washing laundry, run a mainte- 22 |
▯ | Covers with hose holders | nance cycle |
8Drain hose
@ Elbow to form the hose to fit the drain pipe | Importance of installing on a solid, level | |
Washer drum contents | floor | |
2 water supply hoses are shipped in the washer drum. | Your new Bosch washing machine utilizes high spin | |
Be sure to remove each of these items from the drum | speeds to achieve superior water removal from your | |
before using the washer. | laundry resulting in reduced drying time. It is important to | |
| install your washing machine on a floor that will provide | |
| firm support. This prevents the washer from experiencing | |
| excess vibration during spinning that could cause the | |
| washer to move or be noisy. | |
| The installation surface must be solid and level in both | |
| directions. Avoid installing your washer on soft surfaces | |
| such as floors with carpet or foam backed covering | |
| material. | |
| If installing the washer on a wooden floor, observe the | |
| following: | |
| ▯ | install the washer in a corner for better support if |
|
| possible. |
| ▯ | if necessary, reinforce the floor by screwing a water |
|
| resistant wooden board to the floor (minimum of |
|
| 1.18 in./30 mm thick). |
| ▯ | secure the front feet of the washing machine with |
+ |
| holding brackets. A set of holding brackets can be |
| obtained from a specialist store or from Customer | |
|
| |
|
| Service (part number WMZ 2200). |
3
11