Bosch Appliances WAP24201UC manual ~ Remove the transport bolts

Problem	Possible cause(s)	Solution(s)
Water cannot be seen	The water level in your high effi-	No action needed.
in the drum.	ciencey front load washer is below
	the visible part of the drum, this is
	normal.

Water has not drained	Suds may be excessive (usually
completely.	due to too much detergent or non-
	HE detergent being used).

Use less detergent for future loads. Be sure to use only high efficiency HE-detergents.

No spin is selected.	In order to exit the cycle, set the cycle selector to
	Spin/Drain or select a spin speed range, then press
	the Start/Pause button.
Pump is blocked.	Check and clean the drain pump, water drain hose
	and/or the drain pipe.

Drain hose or drain pipe is blocked. Clean drainage pipe and/or drainage hose.

Water is coming out from the underneath the washer.

Water supply hose is leaking: is not	Eliminate the cause: tighten the hose (by hand at the
screwed on tight at both ends, or	washer end), check for rubber washer in place.
rubber washer not placed in hose.
Drain hose is leaking.	Check the drain hose, be sure that it is on the washer
	securely with the clamp in place; may need to replace
	the drain hose if leaking continues.

Foam comes out of the	Too much detergent was used, or a	Immediate fix: mix 1 tablesponful of fabric softener
detergent dispenser	non-HE detergent was used; pump	with 1/2 liter (1 pint) of water and pour this mixture
drawer.	was not able to pump out the	into the detergent compartment (not with waterproof
The cyle status	increased suds.	fabrics).
sequence Wash flashes		To prevent: use less detergent for future wash loads.
in the display.
Repeated spinning.	The Unbalanced Load Detection	To prevent: always load the washer with a mixture of
	system ia attempting to balance the	large and small wash items (easier to distribute in the
	load through repeated spins.	drum).
No spin took place	Load size to small.	Add more laundry.
(laundry is still wet).
	Large items may have become	To prevent: always load the washer with a mixture of
	entangled in the drum and could	large and small wash items (easier to distribute in the
	not be distributed by the Unbal-	drum).
	anced Load Detection system; spin
	cycle therefore canceled for safety
	reasons.
	Excessive suds: too much deter-	Immediate fix: mix 1 tablesponful of fabric softener
	gent was used, or a non-HE deter-	with 1/2 liter (1 pint) of water and pour this mixture
	gent was used.	into the detergent compartment (not with waterproof
		fabrics).
		To prevent: use less detergent for future wash loads.
Detergent residue on	Some phosphate-free detergents	Brush off when laundry is dry or
the laundry.	contain water-insoluble residues	execute the program Rinse.
	may appear as light spots on the
	laundry.

System shakes or	The washer drum suspension sys-
shudders when spin	tem shifts during spinning as the
speed increases.	speed increases. This may result in
	a slight shaking of the washer
	during the spin speed transition.

Mix small and large laundry items together in the load to minimize this effect. Check to be sure the washer is level and all four feet press equally against the floor.

Transport bolts removed?

~Remove the transport bolts; Page 12

31