AEG 14820 manual Problem, Possible cause Solution

Page 38

Something not working?

Problem

The machine does not fill

The machine fills then empties immediately

The machine does not empty and/or does not spin

There is water on the floor

 

Possible cause

Solution

 

 

The water tap is closed (E10).

Open the water tap.

The water inlet hose is

Check the whole length of the

squashed or kinked (E10).

hose and remove the kink.

The small filter of the water

Clean the filter.

 

inlet hose is clogged (E10).

 

 

The door is not properly

Close the door.

 

closed (E40).

 

 

The end of the drain hose

Place the hose at the right

is too low.

height (see Installation

 

 

section).

 

 

 

The drain hose is

Check the whole length of

squashed or kinked (E20).

the hose and remove the

 

 

kink.

 

The drain pump or the

Clean the pump or check

drain hose are clogged (E20). the hose.

 

The

option (stop

Empty out the water by

with water in drum)

selecting the

pro-

has been selected.

gramme or

/

 

 

programmes.

 

The laundry is not evenly

Redistribute the laundry

distributed inside the drum.

manually in the drum.

 

 

 

 

Too much detergent has

Measure detergent

been used.

according to the

 

 

manufacturer’s instructions.

An unsuitable detergent

Use a suitable washing

has been used that

machine detergent.

creates too much foam.

 

 

One of the connectors on

Check that the hose is

the water inlet hose is

firmly screwed on at both

leaking.

ends.

 

The drain pump has not

Fully screw the pump into

been properly screwed on

place.

 

after cleaning.

 

 

The cap on the emergency

Replace the cap on the

emptying hose has not been

emergency emptying hose

replaced after cleaning the

after cleaning the pump.

pump.

 

 

 

 

 

 

 

38

Image 38
Contents Lavamat Turbo Dear customer Contents Page Contents Technical data Service Positioning, connection, starting up Safety instructionsGeneral safety Follow the instructions for positioning and connectionChild safety Proper usePackaging materials DisposalTips for environmental protection MachineMain features of your washer-dryer Description of the appliance Front viewTions Control panelProgramme selector dial Cottons SyntheticsPosition = drying Programme Option buttonsPosition at 40C = Easy to iron This function cannot be used withSensitive ProgrammeElectronic Drying button Delay Start buttonSTART/PAUSE button Programme progress display Drying Time buttonDisplay Has finished, the pilot light comes onOpening the door after the programme has started Cancelling a programmeAltering an option which is running Detergent dispenser drawer Before the first washPreparing the wash cycle Sorting out and preparing the laundryCotton Sort of laundry Approximate Dry weightsTypes of fabric and care labels SyntheticsDelicates 40 Detergents and additives Garments not suitable for drying Preparing the drying cycleLoad As a dryer, the machine works on the condensation principleModification of the drying time or degree of drying Drying symbols on garment labelsDuration of the drying cycle Fibre residueMax. load How to washAdditional drying Load the laundrySelection of the spin speed or option Selection of the desired wash programmeSelection of the desired options Synthetics 900 r.p.m Delicates WoolOn the display appears 0’. Press the button again Selection of the optionStarting the programme At the end of the programme Add detergent and additive Automatic washing and dryingNON-STOP programme Select the wash programmeHow to dry Drying only Max. loadProgramme chart Wash programmesConsumption Special programmesDescrip TionDrying time Spin speed Mins 1400 DryingDegree of drying 900 Consumption data for dryingMax Water Energy Duration Load After each wash Cleaning and maintenancePeriodical cleaning Exterior Detergent dispenser drawerDoor seal Drain pumpEmergency emptying out Frost precautionsWater inlet filter Something not working? TroubleshootingProblem Possible cause Solution Problem Possible cause SolutionNoisy Feet have not been Problem Possible cause E10Foam is still visible even after the last rinse Unsatisfactory washing resultsIf grey stains remain on the laundry White residue is left on the laundryThis appliance complies with the following EC directives Technical dataWater pressure 05-0,8 MPa Service Instructions for installation and electrical connection Safety instructions for the installerRear view Dimensions of the applianceFront view and side view Installation UnpackingPlug the open Holes with PositioningLevelling End of the drain hose can be positioned in three ways Water inletWater drainage Connect the machine to an earthed socket Electrical connectionPermanent connection From the Electrolux Group. The world’s No choice