AEG 1271 Electrical connection, Permanent connection, Connect the machine to an earthed socket

Page 49

Installation

Electrical connection

This machine is designed to operate on a 220-230 V, single-phase, 50 Hz supply.

Check that your domestic electrical installation can take the maximum load required (2.2 kW), also taking into account any other appliances in use.

Connect the machine to an earthed socket.

The manufacturer does not accept any responsibility for damage or injury through failure to comply with the above safety precaution.

Permanent connection

In the case of a permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3 mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point.

This operation must be performed by a qualified electrician.

Image 49

Contents ÖKO-LAVAMAT 1271 T Turbo Dear customer Contents Programme charts washing Contents Technical data Service General safety Safety instructionsPositioning, connection, starting up Follow the instructions for positioning and connectionProper use Child safetyTips for environmental protection DisposalPackaging materials MachineMain features of your washer-dryer Front view Detergent drawer Control panel Adjustable feetDoor Programme selector dial C D F G H J KON/OFF button Delay Start buttonMains-on light START/PAUSE buttonProgramme Option buttons Drying Time buttonPrewash Programme progress display DisplayAltering a programme which is running Cancelling a programmeOpening the door after the programme has started Set the machine to Pause by pressing the START/PAUSE buttonBefore the first wash Detergent dispenser drawerSorting out and preparing the laundry Preparing the wash cycleTypes of fabric and care labels Sort of laundry Approximate Dry weightsCotton Cotton 40Woollens and particularly delicate items Delicates 40Detergents and additives Load Preparing the drying cycleGarments not suitable for drying As a dryer, the machine works on the condensation principleDuration of the drying cycle Drying symbols on garment labelsModification of the drying time Fibre residueAutomatic washing and drying NON-STOP programme Additional dryingSwitching the machine on How to washLoad the laundry Add detergent and additiveSelection of the spin speed Selection of the desired wash programmeSelection of the STAIN, Prewash or Quick OptionStarting the programme Selection of the Delay Start optionSelected programme will appear on the display At the end of the programme Automatic washing and drying How to dryDrying only NON-STOP programmeWash programmes Programme chartWash Temp Fabrics Additional Max Consumption FunctionsType Special programmesMax Consumption Laundry To empty only press1200 DryingDegree of drying Consumption data for dryingMax Water Energy Duration Periodical cleaning Exterior Cleaning and maintenanceAfter each wash Detergent dispenser drawerWater inlet filter Drain filterPull out the filter Emergency emptying out Frost precautionsProblem Possible cause Solution TroubleshootingSomething not working? Possible cause Solution ProblemNoisy Feet have not been E00 DistributedIf grey stains remain on the laundry Unsatisfactory washing resultsFoam is still visible even after the last rinse White residue is left on the laundryThis appliance complies with the following EC directives Technical dataService Safety instructions for the installer Instructions for installation and electrical connectionRear view Dimensions of the applianceUnpacking InstallationLevelling PositioningCarefully level by screwing Water drainage Water inletEnd of the drain hose can be positioned in three ways Directly into aPermanent connection Electrical connectionConnect the machine to an earthed socket